10 FT/LB = ?IN/LB Preload

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Mar 13, 2003
Threads
834
Messages
5,790
Location
North Front Range, CO
I have had problems in the past with loose wheel bearings.
I use the 10 ft/lb method but my Craftsman torque gauge only goes down to 20 ft/lb. I can turn the wrench down to where it would be 10 ft/lb(this my be where my problem is).
Is this a good idea or do I need a second torque wrench?

I have a in/lb torque wrench, what is the conversion from 10 ft/lb to in/lb?
Torque inner nut 3 ft/lbs (48 in/lbs!) from http://www.ih8mud.com/tech/birf-repack.php
Google says "1 foot / pound = 12 in / pound"
So 10ft/lb would be 120 in/lb?
 
12" in a foot... :)
 
Correct The 48"lb would be 4ft lb.

Buck Buchanan
 
oh, and it's not ft/lb it's ft x lb but then again it could also be lb x ft, nobody knows... :)
 
Originally posted by landtoy
I use the 10 ft/lb method but my Craftsman torque gauge only goes down to 20 ft/lb. I can turn the wrench down to where it would be 10 ft/lb(this my be where my problem is).

If your torque wrench lowest point of setting goes down to 20 foot pounds then I highly recommend to use an inch pound torque wrench. Your torque wrench is only calibrated from 20 ft lbs up to its highest point. If you bring it down further than its lowest setting then, the calibration will be out of specs. Good thing you have an inch lb torque wrench.

So 10ft/lb would be 120 in/lb?

10 ft lbs divided by 12 inches =120 inch lbs.:grinpimp:
 
Who would be able to change the writeup?

You go girl! :flipoff2: :flipoff2:

attachment.php


-B-
 
Back
Top Bottom