reset

So I have weird behavior from my front seat heaters. The drivers seat tend to not warm if it was left on from the last start of the car. Each time the car is started, if you turn the heat off and then on again, it works as expected. The passenger side works fine accept it comes on at one...

Hey folks - looking for help with loading TPMS codes on my 200 series. I swapped the wheelset from my totaled '09 LX onto my new '10 LX and want to get rid of the light. I know the serial numbers for all 5 sensors, just need help loading them. Apparently my Techstream cable is missing the pins...

Hello everyone, here I am again...actually I read every morning :-) I closed the egr valve not long ago by cleaning out all the ducts. I always do the reset via obd on android but it's starting to get tedious.... If you're stuck the warning lights come on very often, if you're driving you...

I found on another thread here somebody was having the same issue and it may be a 40 amp breaker or possible fuse. I'm trying to figure out where that breaker might be and how I get at that to reset it, any advice?

2006 200k miles Guys, I have a strange problem and hoping some resolution. I have had alienator checked and battery replaced. here is whats happening , while driving 1) Ist electrics all go dark 2) Orange lights then light up on dashboard 3) Nav screen resets 4) Back to normal but difficult...

'96 with the ABS light on. I've looked on YouTube about using pins 4 & 13 on the OBDII connection but there's no pin 13. I found the OBD1/DTC connection on the passenger firewall and went through the steps with Tc & AB probably 5x but the ABS light never blinks rapidly and turns off. Any ideas?

Mine has been glitching out lately and normally with any Android I just do a factory reset but I'm kind of concerned that doing it with this one will wipe all the proprietary software on there that operates the air conditioner and stuff.

I have the annoying Check Engine, VSC Off, etc. issue on my dash. The code says I need to replace the Oxygen sensor - different thread for that. When I took it in last time the Emissions guy used the code tool and reset the lights, told me to drive 40 or so miles, and come back - no light came...