mounting brackets

$20 plus shipping cost. Pulled from my 1987 FJ60. These have a little surface rust, but they are in working condition! I bought new ones, so these have to go. I’ll include new adjusting springs. You will need screws for the silver ring trim, though.

Warn Remote Control 65014 w/flashlight complete with 5 pin wire harness. Asking $175.00 OBA FJ40 mounting brackets Passenger and Drivers Side $75 each.

Hello, roof rack question. I am in process of getting this from a overseas shop. I am pretty sure it should fit but wanted to ask: 1) If the mounting brackets for all 200 series editions the same 2008 to 2021. 2) If all the 200 series globally also have the same roof rack mounting brackets...

GFC RTT V2 in great condition. Has never been used. Was mounted on my vehicle for about 8 months and has been stored in my garage ever since. Looking to go another route. 80 series mounts from GFC included as well as the ladder and mantis claws. Absolutely nothing wrong with the tent. This...

Just seeing what's out there for a full set and they don't have to be pretty or perfect at all just a complete set

Hi everybody, I'm new to this forum and i just bought a fj60 converted to 2h, but the engine mount that are welded to the frame are not from a hj60 and it is poorly made.... I would like to know if one of you have or can cut and sell engine mount (bracket welded to the frame) from a hj60 with a...

FourTreks Clamps, 1 ¾” Inner Diameter, with Modular Tool Mounts Two clamp rings (these fits factory FJ Cruiser roof rack and any other tube that is 1 3/4 in diameter). Very secure. Rubber clamps are in good condition. These came off my FJ Cruiser when I switched to a Baja Roof rack. Good...

hello I need a couple of the brackets where the jack rod mount on a fj40, they're sort of a pressure clip on for the rod. let me know if you've got any thanks

two tan seats and all the mounting brackets. The floor and the side mounting brackets. So if you want to mount them in something else or make a couch for your shop or office. Also I think these could be modified by taking the foam and seat covers off and attach the frame to a set of slide...

Never used, Hi-Lift mounting brackets. Asking $30.00 plus shipping