Photos attached. 4/72 fj40. Stock as a rock. Rebuilt carb going on so I’m fixing vacuum leaks.
Can I remove these 2 head bolts and then put them back in /torque without causing any trouble? I need more access to replace the manifold studs. I guess I could re-torque all the head bolts per the...
As I was prepping parts and tools, I started thinking about the disassembly and I remembered that meant to ask the gurus here about the head bolts. I have new bolts and washers going on, but when I pulled my head, there were no washers. Im 100% certain of this. Additionally, a second head...
2f head bolts (quantity 2)
Looking for someone who can ship me head bolts for my fj60.
I’m in the middle of a build in borrowed shop space and PO didn’t sent me all of the head bolts. Will need them to get here (Idaho) before Friday!! Only need 2
Thanks
Beehanger
Hey all. So I rebuilt my '73 1F a couple years ago. I just blew my second head gasket since. (1st was due to water pump belt, resulting in overheating) To be honest I'm not 100% sure what happened this time. Water pump spins but it blew all my coolant out and now my oil is milky. I'm hoping just...
I replaced all 8 of my Coil Packs this weekend with Denso packs & Denso Iridium Spark Plugs. When reading this forum I thought that I found the right torque values but, I am pretty sure that the Coil Pack bolts torque was off because I snapped the very first one off. Luckily I was able to get...
Hi, I searched on here and Google and cannot find what the hole in the picture is for and why it is directly connected to a coolant passage. It leaks coolant once you fill it up to that level and if you blow air in it you can hear it in the radiator. It seams to be threaded but the head doesn't...
2f bolts?? by Rkbaseball posted Jul 27, 2017 at 10:00 PM
Does anyone know what the bolts on the heads above the exhaust manifold are for? There is one bolt for each cylinder and they are directly above each exhaust port.
They are circled in red
Thanks!!
I have been around the block enough to know that in every genera from motorcycles to boats there is a hot potato that people get all chicken little about. I searched, but found little in regards to anyone who does not have any HG issues. I'm also not prepared to spend $2000 on a non-existent...
Hi, I am currently rebuilding my 1FZFE and want to use an MLS head gasket. Any issues with using Torque to Yield Head Bolts? Or should I only use ARP studs? Thanks