Serpentine belt making some noise

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 1, 2006
Threads
126
Messages
859
I think its in the pulley and not so much the belt itself but what could it be if it was right there? It sounds almost like a bearing is going out but Im gonna go dress the belts today and see if its just that.
 
;) V-belts....but enough of the technicalities....I would check the trueness of your pullies too, make sure they're not out of round, dented, bent, etc......that happened to my PS pump pulley and caused the belt to shimmy and squeal. Of course, it could just be the belt itself that needs to be replaced.
 
I think its in the pulley and not so much the belt itself but what could it be if it was right there? It sounds almost like a bearing is going out but Im gonna go dress the belts today and see if its just that.

As you are now well aware, mis-speak on the forum, and you'll get eaten. :D

(Insert Girls Garage comment here.)

What you could do next, after the belt dressing...

Confirm age of belts. Confirm Toyota OE.

Then, get a stethoscope or dowel, and listen around. CAREFULLY. It's been done, and done very effectively to chase down where noises are coming from.

Good luck, bud!
 
Still, technicalities or not what belt/s are you talking about?? Serpentine means one that snakes around all the pullies. There is the two sets of belts, the double setup for the water pump & alt. and then the a/c belt.

I found my a/c belt tensioner bearing was making some noise. I also think the tensioner bearing for the double belt setup is also making some noise.

OEM belts should be good and quite for more than just a few years.
 
I had a bad AC tensioner bearing and a missing Alt idler bearing when I got my truck, both replaced shortly after, recently the alt idler has been making a little noise, thinking about just deleting it. tried earlier but oil pump cover leaked without it, gonna have to find a bolt to replace it.

a water pump on the way out can make noise also but have not heard much about bad water pumps on the 1FZ.
 
I had a nice terrible noise when my alt tensioner went. You can check by loosening the belts and manually rotating the pulley. If it isn't smooth rotation...it is most likely a bearing failing.
 
Back
Top Bottom