finally lifted my 45
- Thread starter 65swb45
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
For those who don't want to give pirate the clicks
Very nice. Where did you get the front bumper?
- Thread starter
- #8
I am very proud of that bumper...and of Jeremy! Both are first class!
- Thread starter
- #10
I will be building forward sliders that will replace the running boards as soon as I finish chopping up the bed to mount some more toolboxes.
Stay tuned.
looks great mark
i also liked when ur rig originally too. hope to bump into u in burbank with my LV great job
i also liked when ur rig originally too. hope to bump into u in burbank with my LV
great job
- Thread starter
- #12
Thanks to a very generous swap from Dusty 66, I finally got this long term goal moving forward again. Thanks Dusty!
I've had these old pizza cutters languishing on the swb for 14 years now. I say languishing because MTs were meant to be used, and the odds of them ever seeing dirt on the swb were about the same as the rig getting EFI!;p BUT, I needed a set of clean stock rims and tires to put on the swb before I could permanently relocate these to the lwb.
Dusty had blasted and powdercoated a set of riveted rims for his 66, but decided to upgrade to discs and wanted non-riveted rims. I had an extra set that I didn't need. So we traded, and I bought some ATs for the swb.
They don't look rough and tough like the 35s, but they sure do steer good!
I've had these old pizza cutters languishing on the swb for 14 years now. I say languishing because MTs were meant to be used, and the odds of them ever seeing dirt on the swb were about the same as the rig getting EFI!;p BUT, I needed a set of clean stock rims and tires to put on the swb before I could permanently relocate these to the lwb.
Dusty had blasted and powdercoated a set of riveted rims for his 66, but decided to upgrade to discs and wanted non-riveted rims. I had an extra set that I didn't need. So we traded, and I bought some ATs for the swb.
They don't look rough and tough like the 35s, but they sure do steer good!
- Thread starter
- #13
I didn't have to do any color matching on the rims because all 4 are still in their original paint from the factory! Kind of a shame on a rig that's gonna get run pretty hard. I would consider swapping them with a powdercoated set from someone doing a resto that wants genuine stock paint.
Right now I like the grey so much I don't think I'm gonna even try hubcaps.
Right now I like the grey so much I don't think I'm gonna even try hubcaps.
The tall and skinnies! We need to get another pick side by side at the next 45 run.
Before...
Before...
- Thread starter
- #17
The tall and skinnies! We need to get another pick side by side at the next 45 run.
Before...
If not sooner!
