I had an old rear mount laying around from the 4Runner so I decided to do some fabbing.
Spare Carrier
- Thread starter akarilo
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
- Thread starter
- #2
Done/Complete/Finished/Installed/Over/Etc.
Finished product!
Finished product!
looks cool, nice job
is there a blind spot with it on that side?
is there a blind spot with it on that side?
- Thread starter
- #4
Blind
None to speak of really. I drove it a little while ago and everything seemed normal.
None to speak of really. I drove it a little while ago and everything seemed normal.
nice...
things like that make me with i had not e-bay'd my welder.
things like that make me with i had not e-bay'd my welder.
- Thread starter
- #6
Welder
I hear you. I was without a project for a while but I knew if I sold the welder I would have nothing but regrets.
Get another!
I hear you. I was without a project for a while but I knew if I sold the welder I would have nothing but regrets.
Get another!
hammer1 said:
If you own a truck like ours, you'll never regret owning a welder. I can t figure out how I got along without mine for so long.
Hope you get another soon.
Hodag
euclid
SILVER Star
cbmontgo said:
Looks good. Also, will it rip a hole in the floor of your truck when it start's bouncing around? What's it bolted to?
- Thread starter
- #12
Stable
I'm kinda wondering how it will fare off road. The floor seems thicker and stiffer than my old 4runner. There are three mounting point through the floor with some good size flat washers on the back side. If I have any probs I am going to make a plate for the underside. When I shake it back and forth the whole truck moves so I am not too concerned. We'll see what happens this weekend. I'm going to Hogans off road park this weekend at Disney OK, (nice rocks).
Here are a few shots of the park at
http://www.cardomain.com/id/akarilo
I'm kinda wondering how it will fare off road. The floor seems thicker and stiffer than my old 4runner. There are three mounting point through the floor with some good size flat washers on the back side. If I have any probs I am going to make a plate for the underside. When I shake it back and forth the whole truck moves so I am not too concerned. We'll see what happens this weekend. I'm going to Hogans off road park this weekend at Disney OK, (nice rocks).
Here are a few shots of the park at
http://www.cardomain.com/id/akarilo
- Thread starter
- #13
Performance
No issues thus far.
No issues thus far.
