Recent content by yewtawkid

The o-ring was present in the old ICS. It seemed like the first two "squirts" of carb cleaner had more resistance than the subsequent ones. I will dub it the "Hungarian Rebuild." I feel like I am relatively diligent in changing my filter and using ethanol free fuel. However, at 43 years old and...

My issue was not intermittent, but it did slowly surface. Prior to "cleaning" the idle circuit, I did replace fuel pump, filter, charcoal cannister, and solenoid(ICS).

I believe it was the idle circuit. I removed the ICS and used carb cleaner and some 3mm vacuum tubing to "clean" out the idle circuit.

I read about that in a few other posts. Wouldn't the clicking and the fact that I have 12v dc to the plug rule that out?

Fuel bowl is at half way before and after. I haven't looked with it choked. I will run direct to battery tomorrow. I assume that the only way to remedy a blocked idle circuit is carb rebuild? Thank you!

I have a 1983 FJ60 with 2F-294K miles-OEM Carburetor and new OEM mechanical fuel pump-tachometer does not work. My 60 stalls when it goes to idle. It will start and run when choked, but stalls out as soon as choke is pushed in. It will also drive, but stalls at stop signs, etc. I have replaced...

How did you resolve your issue? I have similar problems. I have "click" and I can see the little pin move on the ICS.

I have a buddy making me a set of panels out of maple. What are your suggestions for fasteners?

It is awesome to have very little worry about "earning" speeding tickets.

US based vendor.

After the OME 1.5" full suspension kit and clutch/master/slave cylinder and front axle rebuild and oil seals and brakes and different tailgate.