Recent content by Viio

6.9 front and 6.1 rear is ideal. You can tighten the front torsion bars to help, but for the back this indicates your springs are tired

Nice work! Hope this works out well for you

Another year of pain and joy

I installed these shock spacers on my 1.5 inch lifted AHC and I experienced precisely zero difference in ride :D

Which King springs did you get? I have the KTRS-79 but it looks like they aren't in production any more

In case it helps, I made a video after getting mine up and running. It was a wild ride. I bought this cable: https://www.amazon.co.uk/Diagnostic-HugeAuto-Techstream-Softwares-v13-00-022-b-obd/dp/B07PDZ4J42?tag=ihco-21

Felt sexy today. Might buy a 2 inch lift then delete the videos after.

Hi folks, does anyone know if the ETCS should have permanent live connection? I've just had a look at a car (2003 2UZ petrol v8) which has an engine light permanently on, and it's blowing the 10 amp fuse for the ETCS. It gets P2118 and also the C1201 generic code. The accelerator won't go past...

My absolutely disgusting first year costs on the Land Bruiser :D

100% the fronts are about an inch shorter so they'd fit in that gap more easily. I've got a set on my workbench if you need any photos or measurements. That does indeed look like a rear globe fitted to the front.

I got my globes from an ebay seller called jpanime. Arrived in the UK in about a week, and it took me an hour or so to install them. I was blown away by how straightforward it was.

Pulled apart my AHC sensor since my height went crazy. Springs all rusty so that's dead.

That's some tremendous advice. I didn't realise I'd end up with that shock contact once the spacers were installed. Thankyou - I'll do some more research

I think I'll just end up draining the entire system. We'll call it a flush. Fluid in there is only 2 weeks old.

Yeah I've tried it with it in Low mode, and with it set to Off. I even drained some fluid out of the system and the pressure didn't release. It's like the shock itself is full pressurised and I can't get it to release.