Recent content by URJ200

My Fan pulley had some of the previous serpentine belt melted/welded to its surface, as the belt runs across the top. It was not going to come off and I didn't want the new belt laying across unevenly so I swapped it for new. Otherwise, likely not necessary.

In addition to above, I replaced these at the same time: Fan Clutch - 16210-38071 Pulley, Fan - 16371-38010

Ill be honest, I would usually agree with leaving out the cover, however recently the section of the roof in front of the sunroof has started to peel the clearcoat (its an 08). It has been a slow process and not really an issue as it was previously garaged but now is parked outside 100% of the...

The cruiser will be parked outside for 9 weeks. I have a higher-end car cover and plan on disconnecting the negative battery cable before throwing the cover on. Interested in any suggestions, tips or other considerations regarding long term parking or storage of your 200. Unfortunately...

As previously mentioned, the value of a quality scan tool cannot be overstated. If you get a Bluetooth adapter and pair it with OBD fusion or similar you can monitor trans/engine temps and other useful data. I always include a breaker bar, torque wrench and jump cables in the kit I'm...

Ordered belts for LC, Camry and Tacoma from McGeorge Toyota, all 5 belts were Bando

Previous member, new account. I have experienced both situations after replacing sensors on my 08. Once, the light was off before departing the tire store. Another time, the tech stated the light was on and would go off after driving a bit down the road, and it did as he stated. Both instances...