Recent content by Tojo64

Cleaning up the garage a bit I found this. Chain is broken off from the cap but still connected to body. If your local you can have it. Portland, Or. Would probably cost $10 or so to ship.

Sorry guys, engine is long gone

That is early. Maybe would explain why we have different air cleaners. Large window carb SD40? I’m so jealous!

The joy stick coming through the trans tunnel cover for the PTO?

You should share the vin. Ours are both FST models in the same factory color in Oregon. Wonder how close they are.

I have a set of 64 running boards. Pm me if interested. You have a solid base to go resto with. Wish mine would have been as nice.

Mark, shiipped the manifold, the manifold to block bolts, washers, retainers and nuts today. I’ll give you a call late next week once you’ve taken receipt. $40 just in shipping. fml. Glad we could work something out.

I’m thinking I should place my old tub back on for mock up. Get perches relatively close and tack. Then take measurements to decide what to due with the tub. Looking at it, the factory tub looks like it will take a ton of work and a skill set i haven’t proven to myself I’m capable of yet. I know...

White stripe thank you for the words of wisdom! I tend to get too particular about things which draws out projects. I already have fj62 front and rear axles, springs and a shackle reversal kit/spring outboarding. Should I wait to get the tub on before installing? If i go with the 60 rear...

It’s been six months since working on the project. I need a serious revitalization to this project. Maybe spending some time back here on mud will give me some motivation.

Can you post a picture of the wand you are using to paint the box section interior?

I kept some bolts/nuts. Not sure if they are of any value. I'll take a look at what I have. Don't let me forget. If I haven't pm'd or responded here by the weekend send me a message.

You are lucky. I believe I pulled those off before it went to the scrap yard. I'll take a look. Wouldn't it be a good idea to get rid of them with the fj25 manifold I have

@65swb45 glad you could put it to use! Didn't know if you needed the clamp or if it was original so I mailed it attached.

Why not use foam ear plugs in the holes? That's what I've always done. Much cheaper