Recent content by toadshade

I don't know about that part in particular but I give Cruiser Corps the highest mark on parts and support. Those guys are just the best. And they have been around for years. I would think that if you had any issues, they will help. They even find and ship big parts for my imported HDJ.

I looked around before starting this thread (heaven forbid asking a duplicate question). I haven't found any info on it here at least. I was actually pretty surprised it hasn't come up before.

Ha! Great advice thanks. Yeah, my wife never found out that I completely sanded and reglassed my whole paddleboard in the kitchen when she went out of town for the week. But this is encouraging. Looking forward to giving it a try. Mine are completely shot. The process I mentioned above...

I want to try to unseal the glass from the reflector so I am looking for a light that would normally be considered poor or not sellable. If anyone wants to make a few bucks on what would normally be considered trash. Glass can be broken. Either side. Mine is a '92 but any 80 series should...

Great to know. I am very familiar with butyl. If that is all it is then great. I should be able to work with it. I need to find an old broken one for a few bucks that I can play with.

Great OK. Good place to start.

Yikes. I was afraid of that. Even if I get it off, I don't know how I would get it back on very well. But I did a little research on what the actual process was that "chromes" plastic. That is where the Cosmichrome question came from. Evidently it is the same as the OEM process they use for...

My reflectors are shot. I am thinking about re-chroming my headlight reflector but before I go through the trouble of removing the headlight, I wanted to know if disassembly is even possible. I cannot find any OEM or aftermarket reflectors. Only upgrade kits. Which are fine if I have to go...

I have a dual axle trailer with drop axles. All of a sudden my foot is dragging the ground and it looks like I am tongue heavy. My first thought is that my front axle suspension failed somehow. The trailer is heavy and I would have quite a hard time lifting the whole trailer off the ground to...

With any luck I just changed my post from my phone to show the rear right passenger side of my car, with the original belt above and the new one below. I immediately took a look to see if I could remove or change any parts but I really don’t see how it is possible. All the rubber is crimped in...

I bought a new one from Amayama but of course it was black. I am looking for a chrome one to match the rest of my car. It is the exterior strip under the window which includes the wiper. 80 series.

OEM bought from Amayama. Brand new. Mine is Chrome and they sent me a black one. Shipped to me was $61 but just make me an offer. Toyota 75730-60020 - MOULDING ASSY, REAR DOOR BELT, RH

Probably everything you need to know in this thread. Not much to it other than building or modifying the brackets. I ditched mine though and went back to some recovered LC seats. I decided I like them better.

Great thanks.

OK. I take it as either pump should feel more or less the same.