Recent content by TEQ

Uglina is doing awesome. I know you were wondering. I'm ordering a new fuel tank. I've replaced everything else that might contribute to the fuel smell. The clutch went soft the other day. Master was dry! I wonder the last time I checked it? Some fluid and bleed made it all good again.

Latest. I'm "done" with mods. Very happy with this rig.

New wheels.

Been a while. Lots of good updates... I had the front clip protected with clear film. While there I had the roof turned black with clear film too. I purchased and installed the Nytop extended fender flares. A little bummed they are fiberglass (or some other simliar material) and not injection...

I know this rig and owner well. Lives around the corner from me. I’d have already bought it if I didn’t have so many other projects.

Uh, I've been schooled that Westcott does NOT use robotics for welding. They have folks like this on staff: https://www.instagram.com/camdenmills/ Wow. Makes me love my purchase even more.

Good question. According to the various sites: - Victory4x4 Strike Rear Bumper: 139lbs - Victory4x4 Blitz Front Bumper: 50lbs - SmittyBilt Winch: 70lbs - Westcott Designs Sliders: 115lbs So roughly 375lbs.

Wescott Design sliders came. Well packed. Wow, the build quality of these is amazing. Clearly robotically welded. Beefy as heck. One hole (right rearmost, on the bottom) needed to be elongated about 1mm to get the bolt in; i reported this to Wescott. Instructions were non-existant and...

Ha! love the license plate.

Skid plate did its job. More than robust enough for this kind of abuse. It was easy to whack it a few times in key places to straighten it out.

Get the Lexus out. Put the TEQ in. Def no hole in skidplate.

Nope, just dirt. No hole (although it does look like it in the pic). I misjudged a hole about 1' in diameter as I was about to head up another rough spot. I was going too fast and the hole was deeper than it appeared (full of water). The rightish side of rig came down hard on the ground (no...

Kennebec Notch.

Cleans up nice. I’ll get it on the lift this week to straighten out that skid plate.