Recent content by tbwingy

Most Excellent information!! Thank you!!

Hi there, what terminal should be tested with an ohm meter to determine if relay is working?

From Tricky's comment above please confirm: Socket is the wiring harness and the #3 is the upper right in the photo. Run a wire from that female to the +12v battery terminal, correct? Connect the male terminal on the relay to the ohm meter, correct? #3 would be upper left in the picture...

I just found the other "crank no Start" threads and will work through those for now.

HI guys, 80 series 97 LC used to be daily driver but for now is sporadically driven. Will sit about a month and would be hard to start but now not starting. I've changed the alternator (it was bad), new belts, new toyota fusible link, new battery, NGK wires, Toyota distributor, Toyota rotor...

Found a few different part suppliers and brands for the heater valve. Do you have a preference? Thank you!!

Awesome info! Will do. Thank you! Any other tips greatly appreciated.

Roger that regarding this thread! Was about to spend money on new EGR, vacuum modulator and VSV out of frustration. I had replaced/cleaned many of the tubes and ports with no success but this thread kept me going. Finally, I replaced the larger tube from the bottom of the EGR vacuum modulator...

Awesome info. Thanks guys! Wise to apply sealant to the front and back of the paper gasket? If so, which brand/type?

Hi guys, incredible amount of great information here. I looked through the chain but could not find part numbers for inner and outer bearings and seals for rear full floating axle. I have 97 with center diff lock only. Rear axle is leaking behind dust cover. I found the inner Timken numbers...

Does anyone know the correct torque for the O2 sensor nuts? Thank you

10-4, thank you. Rubber or poly?

Hi Crikeymike, I have a 97 LC with 2.5" OME installed by PO. PO says 850 springs in front and 860 springs in rear, but does not appear to have installed caster bushings. Will your 2.5 degree rubber caster bushings work with this OME lift? A friend recommended your products, but just want to...