Recent content by svaillan2

Awesome..Thank You

What is the latest list of parts still available? Thx

Hello All, Does anyone know of a source that lists all the bolt sizes for common areas of the vehicle? For example: Rear Door hinges, Front Door hinges, Hood hinges and so forth. Rather then replace 1 missing rear door hinge bolt I figured I might as well replace all the screws at the same...

Greetings all. Well I officially have my 1976 (Dec 75) "Short Bus" alive an running. Now the fun part of fixing everything from it sitting in a barn for past 3-5 years. Anyways the previous owner broke the drivers side rear jumpseat bottom and constructed some makeshift seat from wood and...

Is there any kind of one sided tape or rubber that should go between the tank and tub?

Awesome thank you all for the help!!

Specter has the 2" line but not the filler vent line, screws or gasket that I could find.

Hello everyone. I need some guidance or direction. I have an all original (minus Smog) 76 (Dec 75) that I bought back in May. It had been sitting in a barn for about 4-5 years. Ive replaced all the fuel lines, fuel filter, carb and gas tank due to some exterior pitting on the tank. I was...

How well does the electrolysis work on an object with paint as well as rust? Never done it and might give it a shot. Also has anyone power coated on top of the left over galvanized metal? I've been reading up on powder coating and a lot say to still media blast anything galvanized. Any experience?

To neutralize the acid for sure..... do a quick soak in a solution of baking soda and water. Since I am going to sand blast following the acid soak I just do a hot water rinse. But if your gonna paint I would do the baking soda solution.

Here are the particles of rust and paint left over.........

So I have a factory style carb and I will rebuild the one I am removing. I realize I need the spacer. What I'm asking is do I need the rest of the plate that is attached to the spacer? In this picture the riser that I drew a yellow line around has either been cut or separated from the rest of...

Jim sent you an email and contact form on your website about a desmog. Please get back to me when you have a chance. Thanks Steve

Is steering wheel for sale and will you ship?

Hello all, I was putting on a new non smog carb on my 76 and noticed that the "Carb Insulator Plate Spacer" was either cracked or had been cut by the previous owner to separate it from the carb riser block. Yet it was still bolted in. Now my question is do I need it? I've seen quite a few...