Can anyone please help me source a Dual Cab 79 series LHD? Preferably the previous gen I believe 2022 and before.. not a fan of the round lights on the newer model.
Hoping someone can help us!
Super mystery!
We have an 81 hj47, 12v from Australia (used to be an emergency response). While driving we started smelling burning and then the rig went completely dead. We found that the Preheating Timer (pn 28521-68030) was what burnt up. Not sure what caused it...
I have a 24v jdm HJ61 and trying to upgrade my lights. A bit confused with all the answers but would I need a harness swap too?
Also why are your hella glasses shattering? From impact or heat?
Has anyone put in LEDs from Amazon?
I just installed omesd23 on my AUS HJ47. but it didnt fit as well.. does the pin sit concentric with the rubber bushing? Mine is off axis and I can't get the pin to fully seat inside the bracket holes.
noted! that's another thing I cleaned last time but thought it would be a pain to maintain.
please accept this virtual beer until we make it out there:beer:
thanks a bunch! really don't' know what I would have done without this forum.
That actually looks like the filters I just took out! Thank you!
Do people also retro-remove the centrifuge? I have to change the o-rings on it on my next oil change as it's leaking..
Trying to get the rig a little more bulletproof and ease of maintenance.
thanks! I just got it to work!
Just had to crank it a few times and then let some air out of the line and repeat.
Do you have a part number that would be a good replacement? Not sure if it's easily swappable with the hard lines.
I think I see single vs dual.. any good reason to go with either?
I'm hoping someone could help. :)
I have the dual filter setup, so would there be 2 screws or is it still one? Mine has 2 different screw but I only did the one that had a nipple on it. The other one is horizontal and square so I didn't bother touching that one.
After bleeding the filter and...
Do these sit right on the windshield and utilize 18inch blades? I have a rhd as well and realized the stock ones are bolt on blades.
Picture would be great!
Can anyone tell me a little about how 33s affect driveability and highway speeds? Does it also affect speed on highway hills? I'm on 31s now but have a hard time going up large highway hills. From stop I'm also getting out of first gear super quick. Thanks it's the first time really dealing with...