Recent content by SUMMIT CRUISERS

  1. SUMMIT CRUISERS

    91 80 running issues

    Have you changed this? The fuel pump strainer is notorious for restricting fuel flow as the fuel temperature raises. Super simple to change and under 10 bucks.
  2. SUMMIT CRUISERS

    "Frankensteined" 93 FJ80

    If you're having shifting problems on a FZJ80, two things to check first: Fluid and the Neutral Safety Switch (NSS) grey barrel connector located on the driver's side of engine in back. Need to remove driver's tire and inner fender guards to inspect. These are notorious for getting corroded...
  3. SUMMIT CRUISERS

    valve adjustment? 92 3fe

    Needs a valve adjustment. 8th post down explains the way I do it. Couple tips that I didn’t mention below: break the adjustment nuts loose then re-tighten just a bit before starting your truck and doing the adjustments. Also make sure your AC is off and rpms are as low as possible...
  4. SUMMIT CRUISERS

    For Sale COPART - 2020 LC Heritage

    VIN is shown in last pic on Copart. I'm sure the insurance co doesn't want to deal with unknown's of the repairing of it and/or the owner not wanting to own a repaired LC. Taking it to Copart is the easy way out. They probably have a high reserve with the hopes of someone buying it and a...
  5. SUMMIT CRUISERS

    For Sale COPART - 2020 LC Heritage

    And only 301 miles. So sad. Hope all are OK. Airbags deployed all over the place.
  6. SUMMIT CRUISERS

    1992 Land Cruiser No Click or Crank - located in Northern VA

    FYI the EFI relay has nothing to do with the starter. The battery connections, fusible link, starter itself or the trigger wire from the ignition switch is not providing full power to engage starter solenoid. Check what is cheapest and easiest first. Battery connections, starter connections...
  7. SUMMIT CRUISERS

    3-fe tire size questions

    Anything will work for overlanding including stock. The two main questions you will want to answer is performance and the look. With a 3" Lift you will want 35's. Anything less in my opinion on an 80 looks too small. 1" lift 33's look perfect. 4.88's will work perfectly with either choice...
  8. SUMMIT CRUISERS

    80 Series FENDER FLARE GASKET sets

    PM sent with PayPal payment instructions. Thanks, Steve
  9. SUMMIT CRUISERS

    Click no start after trying to remove crank pulley bolt

    Sounds like battery is down a bit. Try jumping it. Quick and easy. 12.3 is fine but under a load trying to start is probably considerably less. Still no crank and just a click, check battery connections.
  10. SUMMIT CRUISERS

    Newbie help. Driveline lash...trans or transfer case issue!?

    Most 91’s and 92’s have “the clunk”. Wouldn’t worry much and don’t waste $ rebuilding your TC. Might want to check front drive flanges and driveshaft slip joints for slop.
  11. SUMMIT CRUISERS

    FJ80 Tranny / Shifting / electrical problem

    Here's another thread with a pic of it. I know it takes some long arms to reach it and work on it. That's why the up high comment but below the Pesky heater hose. https://forum.ih8mud.com/threads/stuck-nss-connector-help.1050628/#post-12299933
  12. SUMMIT CRUISERS

    FJ80 Tranny / Shifting / electrical problem

    If you haven't done so yet, please inspect the Neutral Safety switch barrel connector. Located driver's side, back of the engine up high and is below the Pesky Heater hose as I recall. These things are about 9 out 10 times the problem with shifting due to corrosion that they develop from...
  13. SUMMIT CRUISERS

    Accelerating troubles on 3FE

    When you changed the Fuel pump, did you install a new fuel sock/strainer on the bottom of the pump? If not do that and report back. I have seen this situation occur when the sock/strainer was not changed. I would also change the inline fuel filter on the frame as well.
  14. SUMMIT CRUISERS

    200 Series and Tundra wheels on 100 series photo thread

    From Toyota. Can’t help much more. Been a few years and Truck was sold.
  15. SUMMIT CRUISERS

    1996 Black FZJ80 with lockers 190k mi - barn find

    Clean up and lube float mechanism. Change fuel pump and strainer then run it. Seen worse that are still in service after working on 5 years ago. How’s tank? Probably has lots of rust/stuff in the bottom. That can be cleaned as well.
Top Bottom