Recent content by SquirtRussel

Installed the dual battery kit from Delta about 6 months ago. Now looks like the starter has died meh. Would click but no crank, pulled the starter and looks like I actually have an open field coil (reading from the starter wire terminal to the starter connector terminal) No chance the dual...

Of course! Got it now thanks Phil!

installed the LCP sway bar discos... am I right in thinking that the newer triangular design is to allow for drilling a hole for fitment if your lift geometry is making things not line up? 4" ironman lift.

Custom or otherwise? Sounds great!

Removed the brain under the seat as well as all wiring I could trace out. The wires I cut were at the points that the alarm install instructions say to tap off of factory wires. I left the taps in place and cut the wire going to the alarm harnesses. Also plugged in the old connectors after...

1997 1FZFE LC Yeah I noticed that connector too but location is different like you said. Oh well. Assuming it’s unrelated to my current issues since it was completely unplugged when I found it.

Probably unrelated but I might as well ask while I have the left kick panel removed. I found this connector unplugged, with no female connector nearby. Also having a hard time even identifying it with the EWD, 9 pins. Possibly connector IL4? Although this seems to go to the fuel gauge and fuel...

Yeah all shifter position indicators and warning lights work. Just not the backlight that illuminates the speedo and other dials.

And yes I do have all indicator lights working on the combination meter, except for the main illumination/backlight. Suppose I’ll just have to take a look at the bulb and rheostat.

Thanks for the reply! Yeah I suppose I should just run through the test procedures in the FSM… Also what kind of manual is that with the wire colors in your last pic? Looks nice! Where might I find one?

Hey there folks, Posting here in hopes that some of you may have knowledge that could save me a good few hours of troubleshooting. In the process of fixing some issues with my DOME circuit, I removed my RS3000 alarm system. After correcting all of my issues with that circuit, I noticed the...

Had a short to ground in my Dome circuit, went to remove the drivers side kick panel to check it out and found a rats nest of s***ty crimps and broken connections and about crapped my pants. Spent way too long looking for WTF these wires were and where they went and couldn’t find anything in...