Recent content by Shifterthree

  1. Shifterthree

    Gear Pattern Interpretation

    Rear axle
  2. Shifterthree

    Gear Pattern Interpretation

    Yes, I was thinking that, I will clean and reapply thinner next time I work on it.
  3. Shifterthree

    Gear Pattern Interpretation

    My backlash was .006, I had an oak handle pressed against the locker as I turned the pinion, pinion preload was 20 inch pounds. Just for some history the original setup was .017 inner pinion shim, this was a toyota marked shim. I am installing new: yukon 4.11 gear set, master install kit, and...
  4. Shifterthree

    Gear Pattern Interpretation

    Would anyone like to help interpret these patterns?
  5. Shifterthree

    Introduction

    Yes it is, 4 inch.
  6. Shifterthree

    Introduction

    Thanks I will check it out. Thanks, it's a work in progress. Had it about 12 or 15 years now. Engine was stuck hadn't run in years, three on the tree and stock suspension. Made quite a few changes over the years. The pics are where it sat the day I bought it.
  7. Shifterthree

    Introduction

    The biggest thing right now, is trying to set up this new rear differential. Having some trouble getting a good contact pattern on the gears.
  8. Shifterthree

    What have you done to your Land Cruiser this week?

    I am trying to build a new rear third member, but it is kicking my rearend trying to get the gear pattern right.
  9. Shifterthree

    Introduction

    Newbie here. I have a 1971 FJ40. I'm a 61yr. Old Father and Grandfather in Alabama. Joined to get Technical help mostly.
Back
Top Bottom