Recent content by Shamsss

I fixed the issue by cutting the wire for the fog lights and soldering new wire and connected to the bulb. This fixed my issue as my issue was the oem ground terminal for the fog light was not connected properly

Thanks, after testing the wiring with a multimeter I rewired the left fog light wiring and with the new wires im getting 12v on the fog lights now. Thanks for the help!

Hello all, before changing my fog light bulbs I thought it was just a burned out light as my passenger side fog light was functioning as expected before and the driver not not turning on. I changed the bulbs today and noticed that the driver side is still not turning on I checked the "FR FOG"...

I got it to work on the 98 by directly wiring the same on the passenger side door and running the wires through the door into the cabin and out to the driver side door. To determine if you have folding mirrors there should be a button with the symbol of the side mirrors. I was searching on the...

I decided to install a small module that would auto fold the mirrors on lock and unfold when unlocked. I got the driver side to work but not the passenger side. I have been looking at the electrical diagram for the 1998 LC100 can't find the wires that control the passenger side folding mirror...

I am looking at the Electrical wiring diagram EWD339U for my 1998 LX470. Where can I find the Starter wires for the ignition coil? which wires for constant 12v, accessory start, on wire, and crank wire?

Thank you so much, long time lurker in the forum with no account. glad I made an account for this. As dirtj001 said, both of you helped me for a life time lol. esp this walkthrough i needed this.

Thank you, budget is running low for me and engine was not running properly cause of a P0325 knock sensor 1 issue. Did the bypass and car is now revving up to 5k rpm. will undo the bypass once I get the wiring and the knock sensor replaced.

upon checking each connector to the ECM, there's multiple black and white wires in the center of the connector not visible which wire would be for the knock sensor 1 and knock sensor 2?

Does region change the wiring colours? says on the manual that it should be a white and black wire but I don't see any black or white wire from my wiring harness

Hello, I need help with the wiring diagram of this ECM from a 98' LX470. Specifically I need to find Knock sensor bank 1 KNK1 and Knock sensor bank 2 KNK2 wire. I've searched around manuals online but to no avail. any help would be greatly appreciated.