Samppahj
Reactions
555

Latest activity Postings About Badges Post areas

    • Samppahj
      Samppahj replied to the thread FJ62 Dash Pad Restoration.
      I would try to make a silicon mold of the texture and then put a thin layer of filler or something else and press on the texture with the mold.
    • Samppahj
      Samppahj replied to the thread Hardware color?.
      The company I am using does zinc coating on stainless bolts for one customer. They are "normal" blue color zinc but can be done as yellow also. What is the point on putting zinc on stainless is hard to tell jut it can be done. And for the...
    • Samppahj
      Took it to camp for the first time this year. Last weekend the lake was still covered in ice, it's all open now. Also last couple weeks there's been a skunk under the damn camp, first time in 32 years I've had one out there so I set a trap. Well...
    • Samppahj
      Samppahj replied to the thread Builds HJ60 Snow white.
      I used SEM Color Coat.
    • Samppahj
      Samppahj replied to the thread Builds HJ60 Snow white.
      That could be my Superhero name :p Thank you!
    • Samppahj
      Samppahj replied to the thread Builds HJ60 Snow white.
      Also painted the carpets. I have not found a set new ones that would be either reasonable priced or fit right so had to try to fresh up the old ones. They became ok when faded areas got some color. Then I had to clean the car so the assembly...
    • Samppahj
      Samppahj replied to the thread Builds HJ60 Snow white.
      Glove box lid gave some real headache. Over 2 years ago I painted it but when removing masking tape from the decals i made a fingerprint in fresh paint. It was so close to the decal so I decided it would be easier to start fresh with another one...
    • Samppahj
      Samppahj replied to the thread Builds HJ60 Snow white.
      Work in the rear continued. I ordered new weatherstrips for the rear. Rubber for the opening was so bad so I decided to go with new. And with the same shipping came others also. I noticed that my struts were upside down and one was leaking so...
    • Samppahj
      Well it takes a lot of heat and time to heat up the gas tank to that point it blows up with a small torch. At the sender unit there will be no vapor either because it is quite far away from the breathers an filling tube. And when the lid is out...
    • Samppahj
      Drill out the heads and remove the lid. Then with a torch give a bit heat to the remaining screws and then some freezing spray. Get a grip of the screws with vice grips. They should get loose with this procedure if nothing else helps. First you...
    • Samppahj
      Samppahj replied to the thread Front Bench seat?.
      I mounted the e-brake lever today and thought about you saying to put the wider seat for the driver. It sure does in the way of brake lever. The floor is flat there so maybe the cutout for break lever could be moved towards the passenger seat.
    • Samppahj
      Samppahj replied to the thread Front Bench seat?.
      Does it have to be a full bench or would the double passenger seat be an option? In Finland every 6 series has the wider passenger seat and they are registered for 6 persons. Highroof versions have also a singel passenger seat. You can see the...
    • Samppahj
      Those brackets are for this breather pipe https://www.japan-parts.eu/toyota/eu/1988/land-cruiser-60-62/hj60lg-mnw/4_791530_005_/body/7751_fuel-tank-tube/2#77261D
  • Loading…
  • Loading…
  • Loading…
  • Loading…
Top Bottom