Recent content by ryaneddy16

Question, Will this work similar to a scan gauge? Just plugs into the OBD2 port?

Im pretty sure the sliders are 4Xinnovations sliders

I am about to order exhaust material. I am planning on doing 2 into one and have a single muffler. Would two 2 1/2in merging into one 2 2/1in be too restrictive? Would merging into 2 3/4in be good? Also who's got a good muffler recommendation?

100 fan blade

Well unfortunately the 100 series fan blade will not work. Its too big of a diameter and I can get a radiator hose on the bottom inlet. But I have a smaller 18in fan blade (100 series is 20 in) That looks like I can make work. I have no clue what its off of but it bolts on the 100 series fan clutch.

That is the plan. Only thing holding me back is time and money.

Got my engine harness dropped off to get modified today. Bad news is I am probably not getting it back by the end of the year. Oh well I will get the rest done.

If i remember correctly they are dobison 3in heavy springs with fox shocks

Im using a 100 series fan and fan clutch on here. Trying to stick to 100 parts so its easier to replace if I ever have too.

I was tired of tripping on body panels so I decided to put the front sheet metal on. I tried to straighten out the front drivers fender as much as I could. I think i did okay.

Scratch that I decided to put a Denso pump in. Got the tank all together and finally got it mounted in the truck. I puts some rubber between the tank and brackets so it would not corrode. The tank came with bracket that bolt in to where the spare tire crossmember bolted in and on the coil spring...

I have a stock 80 pitman arm you can have

Clean 60!

Congrats on finally figuring it out!!

CHERRY! cant wait to see it cleaned up.