Recent content by rfakhrai

  1. R

    VintageTeqParts.com ... Did I get scammed?

    Thanks for the reminder to close the loop on this thread. I did, in fact, receive the item, more than a month after I ordered it. I sent a few e-mails to Matt and received no communication back. He helped me out of a pinch when I needed that wiring harness, but a little communication would've...
  2. R

    1FZ cannot jump TE1-E1 and set base timing

    Well now you've got me intrigued, but it sounds like you don't have anymore info 😔 I'm just surprised to hear nobody else on this vast forum has had this issue!
  3. R

    1FZ cannot jump TE1-E1 and set base timing

    Is that the sensor next to the knock sensor on the driver's side head? It runs smooth when cold but has irregular stumbles when idling after warm. No CEL and it drives fine. I hesitate to even call it a rough idle because it doesn't consistently stumble.
  4. R

    1FZ cannot jump TE1-E1 and set base timing

    I'm not sure I follow. If I was 180 deg off TDC the engine wouldn't run right? And even if I was a tooth off wouldn't I still be able to jump the terminals?
  5. R

    1FZ cannot jump TE1-E1 and set base timing

    I replaced the rotor, cap, and seal on the distributor with OEM but the base unit is the original.
  6. R

    1FZ cannot jump TE1-E1 and set base timing

    No it's bone dry. It illuminates when ignition is ON. Are there further diagnostics I can do? It seems pretty idiot proof but I'll have another look! The terminals are pretty loose but I've tried different thicknesses of conductive materials to get a good connection.
  7. R

    1FZ cannot jump TE1-E1 and set base timing

    1997 coming off of a HG job and troubleshooting rough idle when warm. I even bought the fancy tool from HuddExpo and no matter what I do I can't get the check engine light to flash when ignition is ON, and timing doesn't change. Currently shows past 15 BTDC. The diagnostic port doesn't appear...
  8. R

    Throttle body vacuum routing

    Parts diagram might have my answer... they route to each other lol
  9. R

    Throttle body vacuum routing

    Does anyone have a photographic memory of where these two ports should route to? I've stared at the vacuum diagram and haven't made sense of it and I just can't remember. Thanks in advance....
  10. R

    VintageTeqParts.com ... Did I get scammed?

    Well hell. I did my best to search for threads like that but I guess not in the right forum. I am not alone in my frustration. Thanks for digging that up.
  11. R

    VintageTeqParts.com ... Did I get scammed?

    I ordered a pressure sensor wiring harness and USPS has been showing it's waiting for the package since July 19th. I can't get a hold of anyone at the company. I got the recommendation from this forum to order from them, anyone know what's up?
  12. R

    Semi-circular plug - run or replace?

    I thought about doing this but decided not to in case the metal continues to flake from that point and drop into the timing chain cover.
  13. R

    Semi-circular plug - run or replace?

    Sounds like I'll run it. I'm happy to save myself another prolonged wait for the dealership to fulfill an order.
  14. R

    Semi-circular plug - run or replace?

    In the trash can, thankfully. I was brushing it over the trash when the piece sheared off.
  15. R

    Semi-circular plug - run or replace?

    I broke off the lip of one of the semi-circular plugs while cleaning it. Do you all think the FIPG will seal the gap or should I get a new one?
Back
Top Bottom