Recent content by rezcar

Yeah, Rock Auto has NSK and Timken for good prices, not really worth it to mess with the bearings.

Were you able to find the bearings listed in the picture? All I could find were results for Landcruisers and that website on the label isn't usable.

I have a semi permanent sleeping platform with window shades and curtains. Roof cargo box holds most stuff. If I'm on a solo trip, the ice chest sleeps next to me.

Check out this thread, Best Mod for under $100 I went with netting because I think a hard shelf is a bad idea in an accident. My setup doesn't intrude into the middle row space or grab handles.

Nice! I used racecar window netting. By using a bar on both ends, it can be centered over the rear cargo area without affecting 2nd row headroom. Excuse the mess, this was during test fitting with a bunch of other stuff.

Is the steering wheel locked? Does the key come in and out of the cylinder fine?

I was under the impression that they had to be hammered after installation. But now that doesn't make sense, I was severely lacking brain power at that point yesterday. Lol

Hey all, I'm replacing my tie rods, inner and outer. There's a washer that has to be hammered down to create locking tabs on the inner rod. During the install, I was only able to get about half the upper portion of the washer hammered down. I had to link a couple of socket extensions and stick...