Recent content by redrock

  1. R

    Original bumper paint color and paint code

    FWIW, the metallic silver paint commonly used on bumpers, brackets, glove box door, etc, is not "pewter." There is no such Toyota Land Cruiser color. The correct Toyota paint codes for the 4X series are: T1434 Metallic Gray (1968 and newer) T46 Silver Tan Metallic (1967 and older--slightly...
  2. R

    H55F transmission, bolt pattern where attached to bellhousing

    Which flywheel housing is on it now?
  3. R

    SOLD TX : NOS FJ45 FJ40 Tailgate Hinge 68905-90305

    68905-90305 LH, Hinge Assy, Rear Gate Softtop 'B' Type 1/79 to 10/84 FJ4x, BJ4x
  4. R

    Newbie, So I’m sorry for the stupid question

    Or get replacements from Brazil: M/C 31410-98001 Cilindro Mestre Da Embreagen 7/8" M/C seal kit 31420-98001 Reparo Do Cilindro 7/8" Slave 31470-98001 Cilindro Auxiliar Da Embreagem (Completo) Slave seal kit 31460-98001 Reparo Do Cilindro...
  5. R

    FJ25 & Very early FJ40 Front Bumper “group buy” - Gauging Interest

    I will take one LV bumper; plus 2 sets of fj25 front bumper brackets.
  6. R

    Wanted Early FJ40/45 Rear View Mirror

    Looking for the early 40series (63ish to 67) rear view mirror with the 3bolt mount--complete or just the mount. This is for a 67fj45, so technically the -60020 version, but I could also make the previous -60011 work.
  7. R

    Wanted Early FJ40/45 Rear View Mirror

    Looking for the early 40series (63ish to 67) rear view mirror with the 3bolt mount--complete or just the mount.
  8. R

    Help me wire my my 1HZ into my Fj40

    The connector you seek is Toyota 90980-11157 (Sumitomo 6187-3901). Like half the electrical connectors on a Toyota, it is part of a wire harness assembly and generally not available separately. You might try amayama.com
  9. R

    Wanted FOUND Early H41 Transmission

    Toyota and 36100-98003 would disagree.
  10. R

    Wanted FOUND Early H41 Transmission

    Looking for an early (1980 model year and older) H41 4spd transmission. This would have a 16spl output shaft and would have been attached to a single piece t-case. Doesn't matter which input shaft (gas or diesel). The input shaft would have 22teeth and a 1st gear ratio of 4.925. A very...
  11. R

    MUDShip Denver, CO to Las Vegas, NV

    Need to move a 2wd transmission (NV4500) from Lakewood, CO (Denver) to Las Vegas, NV.
Back
Top Bottom