Recent content by Radwelder

So pump will bypass this volume of water if it’s not spinning? This picture is with engine off. Thanks

Pressure washed through both radiator and AC. You can see through them somewhat.

Water pump looks good and 9 months old, replaced when head redone. Pressure test system last week and holds 17psi per FSM. Radiator has no leaks, just flushed and seems to flow water no problem. Temp sender and sensor replace with head. Gauge varies between mid level and line below red when I...

I only overheat when at highway speed‘s past 10 mile drives but when I stop at a stoplight the temperature comes back down. I thought I might not be getting enough circulation through the cooling system so I set up a hose to check flow. If I’m flowing this much water with the engine off is it...

High engine temp is an issue at highway speeds but come back down at idle. Research says I may have a restricted exhaust not allowing flow at sustained high rpms. Havent had the time to get the exhasut looked at but will go there next. MAF was cleaned and ohms check while bench testing the...

I’ve been having high idle problems so I took of the ISC and cleaned and bench tested it. It extends and retracts per the FSM but when I put it back in the truck it will idle correctly but over the course of a 30+ mile drive the idle will increase and max out at 1300. I have tested the ISC while...

I know this thread is old but it’s a new problem for me when I test my ISC valve with positive at B1 and negative at B2 only S1 and S3 move the plunger if I reversed polarity with negative at B1 and positive at B2 only S2 and S4 move the plunger. They do not work in the sequence of 1234 or 4321...

Changed out the water temp sensor and no luck. Now it idles at 1200 so can’t check timing. Going to take off and clean Air flow meter and check ISC valve

I ordered new temp sensor and is coincidence that the idle is higher lately also? 1000-1100 when warmed up.

Carb cooling? Is that the little fan at drivers firewall. If so.....sometimes I hear it but don’t think ever time I drive. Engine temp runs normal except at highway speeds. Then it runs one bar below red. I’m told that may be restrictive exhaust. Hoping to get that replaced soon.

Hello, New to me 1989 FJ62 with startup problems when engine at normal temp. When engine is cold the truck starts within a couple seconds of turning over with no gas pedal assistance. But once its warm it take 10-15 seconds and half throttle to fire. Once its running it seems to have power and...

Need a florida meet up for a weekend somewhere.

You sell a kit complete? And this will fit a 1989 62?

I’ve read the cooler before, any specific size or model?

I have done all my own work on our Jeeps except re-gearing as i dont have the tools for the back lash and shims. Told that Toyota use a adjusting nut. Is it pro only install or a do it yourself person capable. Research says 4.88 to go with 33s and will then be better tow rig for trailer.