Recent content by paymentchad

Especially since it could not even change afterwards! Very frustrating, and wishing you the best to solve it.

Interesting. Mines a 92 1hd-t. I’d ask if he remembers what part number he used for the clutch release bearing and clutch cover. There’s a forum about which ones to use for what year. I just searched “h152 shifting” in 80 series forum and it has all the info I’m referencing. Not saying this is...

Of course! I used everything he provided. I sourced things that weren’t related to the transmission. Just interior trim pieces mainly. What year is your cruiser? I’m reading that throw out bearing lengths are different for early vs late models cruisers.

I haven’t. I watched the video in the thread to be sure of what I was listening for. I used all OEM Toyota parts. Mine sounds smooth but does fight to go into first every now and then when down shifting

RHD brown would be preferred. But lmk what you have

Do you still have this?

Is this still for sale? What’s the price on it?

I went through Back 40 Imports in Kalispell,MT. He provided a compete kit for the swap with all new oem Toyota parts. The only thing used was the clutch pedal.

Here is a summary of parts you may need for a RHD 80 series: 1 H152 transmission 1 Bell housing 2 block dowels 90250-08054 2 transfer case dowels 90250-12002 9 bell housing to trans bolts 91611-61045 1 bell housing to trans shorter bolt 91611-61035 10 bell housing to block bolts...

Day 4 Transfer Case and Master Cylinder Lines Install transfer case Replace your linkage on your transfer case with the new shorter linkage. (It’s closer to the manual than it was on the auto) Be sure the dowel pins are either on the new transmission or the transfer case. Fill with 75w-90...

Phase 3 (Day 3) Installation Install new stiffeners on motor (4 17mm bolts) Install end plate on motor (one 12mm bolt torque to 13ft-lb) Install dowel pins on flywheel (2 total) Install new flywheel (uniformly tighten 8 bolts in several passes; torque to 94ft-lb Install clutch alignment tool...

Clutch Pedal and Master Cylinder Get in the footwell and remove the HVAC relay. Tan box that is very valuable and hard to find. Two bolts and set it safely to the side. Drill holes for the master cylinder in the fire wall. Most already have the center hole for the master. Pull the rubber...

There’s tons of info on this swap but I’m gonna put it all in one forum on the first page! No more going to page 3 then 5 then back to 3 to figure out what you’re doing. Also not here to argue about what transmission is the best for the cruiser, just laying out an instruction guide for a h152...

Ended up being the wire from the 24V solenoid! Such a simple thing but it was tucked down in the engine bay from removing the batteries.

Tried everything and can’t figure this out! I just did a h152 swap from a a442f on a 92 Land Cruiser with a 1hd-t. Once everything was in, I tried starting the truck and nothing happens. Power to car is good, then I turn the key and everything turns off and gives a very slight single click. I...