Recent content by pathfinder1994

Just bought a replacement brake light for over $400. I took out this assembly. If you have a cracked assembly this is for you. You will need to replace the main light and it needs a new gasket. Would be perfect for someone with a fully functionally lights but a crack in the exterior...

Just bought a replacement brake light for over $400. I took out this assembly. If you have a cracked assembly this is for you. You will need to replace the main light and it needs a new gasket. Would be perfect for someone with a fully functionally lights but a crack in the exterior...

Yes I liked them At first after the lift the steering and front end alignment was very messy. But they figured I needed to add the old man emu upper control arms. I had to pay for the parts but they did not charge labor to tear apart and put back together since that it has been great Get...

Nut House Industries is between columbus and Ohio. I had them put on Old Man Emu lift and 33s on my 2010 Land Cruiser. It is mostly Jeeps but they do Land Cruiser work also.

so sad but these went into the trash can

Thanks again. Battery disconnect did work.

do you have a specific tool you would recommend?

VSC system and 4 lo blinking lights. I believe from the Wife not putting the gas cap on (at least she filled it). how do i clear? I have read the forum and assumed it would clear itself. I have driven over 100 miles but it has not reset. any ideas? my next plan would be to disconnect...

Opened. Put in new switch. Works like new.

Funny owners manual. Will report back if the switch works

Help Can’t get the back gate to open. I think it’s the switch. Has not worked great for two years. I bought the switch. But I can’t get the gate open to install. I have heard some descriptions. But I don’t see a manual latch after I opened the small panel on the inside.

Fender Flares from my 2010 Land Cruiser. This is one of those those Land Cruiser that started from Texas so it came with these flares. They are in good condition. Silver. I am sure they could be painted to match. John

thanks. i do see that the 2008 to 2011 show up alot as not compatabile with the 2103 + LCs parts. Have you had any issues in general? or does stuff always fit the 2010?

Hey. I have a 2010 LC. was planning to put the 43136-60020 spaces on. When i went to buy from toyota. the web site says it does not fit the 2010. Did you have any issues with the instal1?

Dare i ask...what are those wheels? look very good.