Wow ok. I had the fenders off when I restored the chassis, I had the body off also. Should have addressed that then but I'm buying new fenders so... I think I need to fix this leak though quickly, since I have new carpet in also. Thanks for the info!
I'll look at that area, thanks. As for the rain gutter in the roof, does that get in and go down the windsheild pillar? I'm not sure that's the term for that?
I'm hoping someone can point this right out. I've had this leak, pooling water, right at the hinge pillar on the floor board at the passenger side. I tried placing tissue paper up above in a couple locations and they were dry, so it's coming from somewhere other than those paths. I just...
Note-These are for the 3 piece bumper, not the typical FJ62 single or one piece bumper. These are Toyota parts, not aftermarket. They are brand new in the box. Left and right. I want $100.00.
I'll box them up and bring them to the shipper, you pay for shipping.
It might be too late but maybe this will help. I used Matts motor mounts and had them welded on by a mobile welder. I wished I had located them 1/2 lower and half inch forward from where I did mount them. I have the same exact power train as you're using. The hood closes just fine but I...
What would be the result If I take the singal wire from the 2000 Tahoe 5.3 using it's oil pressure sending unit that I swapped into my 88 FJ62 and send that signal directly to the FJ62 oil pressure gauge?
Thanks Matt, what I ultimately discovered is that two of my original wires to the battery, with fusible links were loose. I fixed those and installed a new ignition switch. No issues since and no other wires were affected. I don't understand enough about this circuit to figure out why the...
Answer is no, that was just to test. Test is done, can't fault me for taking it apart and looking inside. That switch looks nice Matt. I ordered one already. But I could return it.
I think I might have found the source but not sure yet. I dissected the two burnt wires, they were IG2 and AM2. I covered them with electricians tape and re installed the switch and the truck started right up. I monitored everything closely and nothing got hot. I turned the truck off and did...