Recent content by PabloVTA

so where's it at now? not the timing, the build...

is that Brisket butcher wrap paper as a surface protector? dayum! $$$ick.

50/50 mix of ATF and Acetone or PB Blaster in the cylinders...soak it down... good luck. Unless somethin is bent, it should come back around.

was the oil milky? or even there? whats in the rad? was the steering fluid foamy?

is there a way to check the solenoids for first and second were not swapped when you did the install? what about the check engine/trans function while using a jumper in the diag box? just asking...I'm researching a problem I'm having and have never done a solenoid replacement, but thinking...

check the EGR tube for clogs, the air cleaner tube to the throttle body might have a crack in it too. if you take the throttle body off, make sure the passages to the EGR are clear and not plugged. and the fuel filter on the end of the rail is a cheap and easy fix for peace of mind. might...

No more video? It’s only 10 years old???

whats left? what town are you in? got the trans and tcase still?

interested. w/awning. I'll need to make it flat so i can mount a XXL Baroud RTT, what are those channel brackets along the one side? is that the awning mount? lights not needed either.

sent you a DM...

did this sell? if so...did the new owner take your spare parts? I'm looking for a AFM unit from the air box lid to the hose. thanks.

thats from the web page, what do they look like now? they've been mounted on two trucks so far?

do you still have the stand offs and hardware to mount to the rig? or is this just the rack shown?

im interested, do you have any pics of the hardware and rear brackets? in Ventura..might have to get some Gordo tacos too.

i need 94 parts, do you have the AFM (or MAF some call it) any ECU's or door electrical switches left? im in ventura