Recent content by OOCustoms

  1. OOCustoms

    2024 Leather Options

    Anyone know where to source the second row leather upholstery?
  2. OOCustoms

    1967 LPB restomod full soft top

    I found a shop in FL -The Relik Garage - https://relikgarage.com/ who makes the Troopy versions, but not for the 45LPB.
  3. OOCustoms

    1967 LPB restomod full soft top

    Believe me, I've tried! My local upholsterer retired, no one in this area is willing or capable to take on the job. All the boat shops sub contract out to companies that only do boats.
  4. OOCustoms

    1967 LPB restomod full soft top

    I’m not seeing any message…?
  5. OOCustoms

    1967 LPB restomod full soft top

    Cool truck! My existing rear top is trashed, so I would need the rear section as well. Thank you for the offer.
  6. OOCustoms

    1967 LPB restomod full soft top

    Ideally just one top for the whole truck, but some kind of two-piece would also work.
  7. OOCustoms

    1967 LPB restomod full soft top

    Anyone?
  8. OOCustoms

    1967 LPB restomod full soft top

    Hey there folks- just thought I’d put this out there in this forum. I have had no luck finding anyone who produces a full soft top for the LPB pickup- a couple shops have the full soft top for the LP and LV versions, but no joy for the LPB. Right now it has a soft top covering the bed only...
  9. OOCustoms

    1997 mystery cold start issue

    No- still looking. harness turned out to be ok.
  10. OOCustoms

    FAQ 1995-1997 1FZ-FE FZJ80 OBD2 Main Engine Wiring Harness Connector Information

    Ok so I have been following this thread with interest- lots of great information. I haven't had any luck through search for an answer to my question- I have a '97 that has cold start issues. Low idle , stalling, stumbling for the first 1-2 minutes until it warms up- then it's fine. I believe the...
  11. OOCustoms

    1997 mystery cold start issue

    All the sensors that the ECU uses are new- however I think I might have found where my issue lies- I tested the IAC harness for resistance- (3-10 ohms) and it's way out of spec. Looks like I have a short somewhere in the harness between the connector and ecu. ****.
  12. OOCustoms

    1997 mystery cold start issue

    IAC is new- I guess I can test it to make sure resistance is correct, but chances I got a bad one are slim.
  13. OOCustoms

    1997 mystery cold start issue

    Ok- here’s the deal. When the truck is cold started, it fires right up- idle is around 1000. Within about 45-60 seconds it starts to shudder, idle drops very low, engine surges and stumbles for about 60 seconds or so- sometimes stalls, sometimes comes out of it and suddenly smooths right out. If...
  14. OOCustoms

    My misfire thread..

    Bump- reviving this thread once more- I have the same stumbling/surging idle with no power- only for the first 1-2 minutes, only when it's full cold start. After inital stumbling/low idle it behaves fine, it won't do it again until it cools down for quite a while. Did you guys ever get it sorted...
  15. OOCustoms

    Wanted Australian-style FJ80 Headlight Assembly/Bracket

    @Bardiya Sent you a PM
Back
Top Bottom