Recent content by nudavinci64

I reached out to ICON through our rep (I'm a dealer for ICON alloys), and they noted pure engineering opinion vs who is running them. He responded with 18" +40mm ( 9" wide rim) and 17 +25 (8.5" rim). A bunch of customers run the 17" wheel. In the video, they refer more to a similar 9" wide 17"...

will need to take a look. the +25mm is also a 8.5" wide wheel vs 9" at 40mm

Which part number are the ICON wheels you picked up? I'm looking into the 17" setup for a buddy. What suspension setup did you do, or is this still in stock?

cool there is the sand-free and plastic adhesion. I think most of the toyota's likely need plastic adhesion since acetone does not have anything effect on the panels.

are you guys using sand-free adhesion promotor or another from sem? I assume all the parts are ABS or similar. I tried the acetone test but it did not "melt" so had me guessing before I buy different stuff. I had picked up sand-free adhesion promotor

I was able to get the seats working. Instead of dealing with the memory function, I swapped the non-memory switch and harness from an A4 instead of an S5. These go direct to the motors instead of dealing with the control module. Works like a charm. I used a donor A4 harness which deletes the...

Anyone know if the component protection would cause any issues? Or if I i need to tap the hi and lo or one of the can bus wires? I have not been able to get the power to come back on either seat (one was working) but can confirm the lumbar works on the seats so I know they are getting power...

the canbus idea is interesting. I had it disconnected all night and tried again today with nothing. The seats are not in the vehicle yet and for now just bench testing before I go any further. It would make some sense as after a couple minutes of the driver seat working it stopped. I cant...

yah I feel ya there. for me getting more space to get my kit out or some geer nice to just tap a button to move it out of the way. not needed but its a nice to have feature for sure. Have not had a chance to test heat, lumbar, courtesy light yet. Such a buzz kill that it WAS working.

yah I thought about that but pretty sure i was using the regular seat adjustments before this all happened. But def interesting little tid bit. Right now the top "let someone in the back seat mode" does not work either. All of the buttons stopped working. If there is a way to get it out of...

yah I am using a car battery. Tried on a regular lead acid and a AGM because both were available. I am not as worried about the memory resetting. That would be annoying but need to figure out why they are not working. The one was working for a few minutes then nothing. I had a 10 amp fuse in...

Anyone know what voltage is needed? One was working then stopped. So I assume I had enough. Current is 12.xxx voltage so seems strong.

Working on retrofitting a set of Audi S5 seats. Benched tested the seats and first one (driver) worked for a few minutes. When I came back a few minutes later nothing. The passenger seat nothing. The seats do have memory on them. I was partially wondering if they would even work so was...

Old topic but was researching a similar issue. I found on a new harness (Was using a switch pro before) that the small diode they have shrink wrapped in the harness going to the switch was bad. Traced it all the way to the switch no power when tested on the yellow/red wire. Checking the...