Recent content by NTV

I have one. Satin black for sure. Gives the best contrast.

I run the desert does it without issue. Nice set up. Very pleased.

I do exact same with my in reach mini. Works great.

Slee did mine and pulled the power from the factory head unit. I drilled the holes for my 67designs ball mounts. Exact same as you have and then just reattached the quick connect they had already installed. I also had to rebend those tabs to add the 67 designs mounts but think those tabs are...

Looks great! Mine is wired direct and has been great. I used the Amazon flat charging ports that were on the Gamiviti website. They have worked great. They are wired direct with a a quick disconnected in case I need to swap out down the road. Here is the link. Amazon link not sure same brand...

I am pretty sure I drilled through the plastic to make it easier to get a socket on the nut on the bottom. It was over two years ago and I can’t remember for certain. Old man brain is real 😂. I haven’t had any issues and since installation it has lived up there and when combined with the USB A...

Artie. I installed the 4 point mounts with balls instead of the 2 point 67designs and was able to get 3 of the balls installed across the front of the panel. I had to drill some extra holes but feel like it was worth it. It’s definitely overkill but it’s not something you want to do twice. I...

I have had design issues with my victory skid plates. The overall build quality is good but the design feels like it was rushed and not fully tested. I cannot he the Oil filter housing out of the access cut out without loosening the three front bolts to bring the front skid down a few inches...

Got the code cleared and all is well! Appreciate the help.

mine works great also. Looks really clean after getting it professionally powder coated.

Same with mine. I have put mine through some abuse and think the offset is just perfect for a 200. I also like how they are not crazy expensive. Don’t feel so bad replacing one if need be.

Thank you for the help I didn’t realize it could take a couple trips to clear the code. I will check the valve and hose as well and keep an eye on it. Really appreciate the tips!

The code is showing as a permanent code in my OBD Fusion scanner. The P 0446 code.

I also posted on LRA thread until I found this specific code thread. I have had the 24 gallon LRA in my 2018 LC 200 for a couple years now. Works great. I recently got back from a trip to Utah where too say the least I was not on level pavement :). Had the rig in some fun stuff off road. Had...

I have had the 24 gallon LRA in my 2018 LC 200 for a couple years now. Works great. I recently got back from a trip to Utah where too say the least I was not on level pavement :). Had the rig in some fun stuff off road. Had some venting gas pressure/smell out of the filler inlet so I vented it...