Finally took it out last night! Hamptons for the week. It drove great, but I’m still a bit nervous about the rack- especially when hitting bumps on the road. But we made it! 🎉
Everything attached except for the black plastic end caps. But I’m still wondering if these extrusions held by a few bolts are really strong enough for a 150lb RTT driving around… is the weight evenly distributed to the 4 uprights? Would it make a difference if I added 1 more upright on each...
Hey @perkj
did you use a transition bracket here?
I’m currently just using the 1.5x1.5 extrusions for the crossbars since I don’t have the proper bolts for the 1x3…
@perkj hey! Where exactly did you place the washers on the long extrusions with the Bumax bolts?
While I had the cover off the trailer and I had 4 additional M8 bolts - I ended up adding 2 bolts on each side for the long extrusions...
Thanks to you!
how long did it take you to figure this whole thing out?
If it was me doing this from scratch- I definitely would’ve had to make at least 10 separate orders from them 🤣🤣
Also, what made you use 1x3 extrusions rather than the 1.5 x 1.5 for the cross bars?
I have a couple of spare Thule crossbars laying around somewhere. Hoping one set will fit- I know they’re mostly T-slots so I’m not too worried about that part..
I did 52” extrusions for the sides and the same 18” for the uprights...