Recent content by NextVentureDan

  1. NextVentureDan

    Finally got sliders I like

    ~162 lbs.
  2. NextVentureDan

    Finally got sliders I like

    Those pictures are of the prototype; everything built after that sticks out an additional inch on each side (2x3 tubing instead of 2x2)
  3. NextVentureDan

    Finally got sliders I like

    There's a couple decent up-close shots of the mounted on the product page here as well. http://www.nextventuremotorsports.com/product/tlc80-sliders/
  4. NextVentureDan

    Finally got sliders I like

    Mandrake, I don't think that would be an issue at all. We could bring them up an inch on the mounting plates as well to accommodate the 1" body lift/stay closer to the pinch seam on the body. Qball, The cat skid has thirteen 2"/1.5" holes as well as a generous gap around the control arm...
  5. NextVentureDan

    Finally got sliders I like

    Looks good! I do see some welding and new exhaust components in there which was not our goal for "completely bolt on sliders" but either way certainly works.
  6. NextVentureDan

    Finally got sliders I like

    I have a hard time imagining what legal issues I might run into advertising that "you must remove federally required emissions equipment" with a set of rock sliders haha. I think a lot of people want to leave them as they are/intact. Wouldn't be too hard to build sliders for a non-US spec 80...
  7. NextVentureDan

    Finally got sliders I like

    Also very happy to see the sliders getting some attention here - we're quite proud of them. Thanks Fosters!
  8. NextVentureDan

    Finally got sliders I like

    Our website was not correctly calculating shipping options when that order went through with the Flat Rate/$42 shipping - and that's on us, so we covered the difference and fixed our shipping calculator. I'd like to improve that somehow but the shipping is a bit pricey on that much steel...
Back
Top Bottom