Recent content by Newrider

  1. Newrider

    Cute Story

    so yea, I replaced the intake/exhaust manifold gasket....and I have made sure that all of the vacuum lines have been replaced and sealed. I did a compression check and all of the cylinders are between 120-130. I've checked plug caps...and I rechecked the timing. I think the brake booster was...
  2. Newrider

    Chipmaster gets a new 465 and Orion...

    poser, you got pm
  3. Newrider

    Cute Story

    how do you check to see if the points are sticking? ryan //newrider
  4. Newrider

    Cute Story

    new points and condenser, dizzy doesn't slip at all
  5. Newrider

    Cute Story

    It was through both. I'm going to go do a compression check again on all of them, try cleaning the carb out more...and then if that doesn't work i'm going to pull the carb again and inspect. Sound like a good plan?
  6. Newrider

    Cute Story

  7. Newrider

    Cute Story

    I popped the top of the carb off yesterday and it didn't look like much was in there. I took an air compressor and blew air into the jets in the fuel bowl and down the idle/mixture screw. But like I said, it didn't seem as though much was in there. Also, when I popped the carb off, it didn't...
  8. Newrider

    Cute Story

    will do
  9. Newrider

    Cute Story

    bump
  10. Newrider

    Cute Story

    anyone?
  11. Newrider

    Cute Story

    pinhead...what it does is at low rpms it is backfiring like crazy out of the carb and exhaust...it stalls itself. At the high rpms with the choke 3/4 out, it doesn't seem to be backfiring. I have tried messing with all the adjustment screws on the carb and they don't seem like they do much. I...
  12. Newrider

    Cute Story

    bump
  13. Newrider

    Cute Story

    I checked the timing again. It is correct, not the 180 degrees off. I've sprayed around the intake manifold below the base of the carb and it isn't leaking. I have checked the gaps on the plugs, all are fine. The idle adjustments on the carb seem do nothing. I'm sure I have the firing order...
  14. Newrider

    Cute Story

    I guess I can't say that I'm 100% sure that I'm not...but I was 360 degrees off and we fixed that....so that is why I guess the timing is where it should be. How can I check?? I put it on TDC and then adjusted the ball to the arrow. I also know the plug wires are in the order of 153624.
  15. Newrider

    Cute Story

    I got ya....But I know the firing order is correct...and I know that the timing is correct as well. I just can't figure out where I would have another carb leak. Anybody else???
Back
Top Bottom