I rebuilt mine because I was lucky enuff to have a shop in my town...they have since closed. now I have to travel a few miles to get rad work done now. If I have to replace it anytime soon, I certainly consider buying all the aluminum radiator I can afford...:idea:
Which model Viair compressor is that? I am leaning towards building a similar setup using an old spun aluminum medical oxygen tank for storage...:rimshot:
Depends on material used for radiator (aluminum or copper/brass) and your driving conditions. Since you are in Tx, I would recommend getting all the radiator (4 row aluminum) you can afford. Radiators are not a place to be tight with a buck, it's where all cooling is accomplished. 3-row is good...
Things to start with: confirm battery voltage at starter wire ( have someone turn key while you use test light, or spring for volt/ohm meter) then if you have voltage reading there, leave wire off and go to step 2
2nd: confirm you are in neutral, block wheels, and jumper a hot lead from starter...