Recent content by MVZ

As I understand it, you need to look at the diagrams for the Cruiser 70: RM315E- 08.92 / EWD168F 08.92 and RM321E- 08.92 -pinouts.

So, the exhaust gap, while your average was 0.3, now reads 0.05 (using the smallest feeler gauge). That's 0.25 decreased per 100,000 km = 0.1 per 40,000 km.

I don't use lubricating fluid. Unfortunately, this is the average usage statistics for LPG systems in Russia (PBT and PBA gas), not just on my car but also on other 1FZ-FE and similarly 2UZ-FE models (exhaust valves 0.1-40,000 km) – they deliberately increase the exhaust valve clearances by 0.1...

I have an LPG system, adjusting the valves every 30,000-40,000 km (they go from maximum to minimum), set the ignition to 7 degrees, the LPG system is configured using OBD1 corrections (Cartester8000 via cable), switching to gasoline at 2700 rpm. The lambda sensor is working properly - checked...

I don't have a photo, but I did it 10 years ago. I pulled out the axle and removed the lever, and marked the outline on the plate (using drills, a round file, and a vise). I drilled and sawed it out so it would fit snugly, and then filed down the outline on the outside to leave a sufficient...

I glued it with superglue and it broke, then I made a bandage from an aluminum plate (2-2.5 mm) and secured it with epoxy glue - it has been working for many years.

A friend had exactly the same problem with his dashboard speedometer: a resistor or transistor burned out, but the needle kept working. Inspect it carefully; you might be able to see what's burned out.

T- taillight, EL -Light earth, H-headlight, HF-headlight flash, HU-headlight upper , HL-headlight lower, ED -dimmer earth

Gulf 08/19922

Gulf 08/1996:

33281-16020 33281-16020