Recent content by MojoCruiser

@fjdemon Picture # 1 This is the best before side profile pic I have: Picture # 2 This is an after suspension swap shot: Pic #3 An up close view of the after suspension swap wheel well The first measurement was 1.5" of front lift before initial settling and the current is still at 1.25". No...

I'm currently running 275/55R20 Cooper ATPs and I'd like to put 275/60R20 BFG KO2s which is going from a 31.91" tire to a 32.99" tire. A 1.08" or 3.4% gain in height. or 275/65R20 BFG KO2s for a bit taller tire. That would be a 34.07" tire and 2.17" or 6.8% increase in hieght. The 65 may be...

Thank you for the info. Very interesting reads. If theis wasn't my wife's everyday grocery getter and kid transport I'd go with the Toytec Radflo combo for the front (3") and the Dobinsons Rear Coil Spring For Toyota Sequoia 2008-2016 1.77" lift (45 mm) with a 1.5" spacer to bump it up a bit...

Good question, I wish I would’ve been more intentional in the before pictures but let me see what I can find. I will post some after photos for sure. It’s been unusually bitter cold in South Texas lately. Of course, it’s not a seriously drastic difference but in my opinion it does look a...

@expolander

Old and new... next each other Same height but definitely not the same load rating... And the new TRD Offroad sus components installed...

Old clapped out components...

After measurements: -From ground to fender 36 & 1/2”

Before measurements: -From ground to fender 35 & 1/4”

The idea is to be able acquire a low cost OEM lift for those that are just wanting bump up the front end of the 2nd gen sequoia on a budget. IMO it has a nice leveled look. I might actually go for a protune 1” rear spacer ($79 Amazon) for the rear springs. Ill have to see how it looks. I’m...

Done with the Tundra front Suspension Swap and I’ve got results... (BLUF: 1.25” front lift!) Before measurements: -From ground to fender 35 & 1/4” After measurements: -From ground to fender 36 & 1/2” My Vehicle specs: 2010 Toyota Sequoia Limited. Stock rims with 275/55R20 Cooper ATPs. 107,xxx...

Update:I ended up just getting the front coilovers because when I compared the rear shocks to each other and the sequoias have a welded eye mount (top and bottom) and the tundra’s rear shocks only have a single eye mount with a top nut on the upper side. -more to follow... I hopefully will do...

Working on getting a set of 2018 Tundra TRD Off-Road coilovers and rear shocks from a buddy of mine. I prefer to use the Toyota bilsteins (yellow & Blue) so I’m holding out. He should get his toytec kit in soon and will have his oem components swapped out within the next two weeks. I’ll keep...

@MoSequoia I love what your doing with your Sequoia! Looks sweet! any thoughts on this... (Not trying to highjack...) it's about time to switch out the shocks on my 2010 sequoia's (limited/non air ride) suspension. -When I had my 4th gen 4runner, I switched out the old suspension with a 2nd gen...

You can tell a distinct difference between the halogen fog lights in the new LED headlights. This is my wife’s second generation Sequoia with stock headlamp assembly. Overall, I am really pleased with the disbursement of light and apparent brightness. Just ordered some led 1945 fog lights so...