I just got the AC working and fixed a boost leak. With the AC on full driving up hill in 90* heat it stays cool as long as the fan is on. Since I have the intercooler and condenser in front of my radiator with room for air to go out the sides in between each one I think my heating problem is...
Its been a while but I ended up buying a trinary switch and a ac hose crimper. I found a wire under the dash that comes on when the ac button is pushed and the blower is on. I ran that to the trinary switch and then to the ac compressor and the fan relay. It works great just in time for...
I bought a hose splice to add a trinary switch and some other splices to better route the hose. I am just waiting on them to arrive. I should have all the parts in a couple of weeks. From talking to Coldhose I got the impression that using a thermistor was more necessary for R12 but R134a the...
Several of the wires ran through part of the harness that I removed for the engine swap. I tried to keep everything that I would need and so far this is the first stuff that I wish I had kept. Hindsight's 2020. I found the wire that gets power when I turn on the AC so I am planning on running...
I've been working on this all morning and every time I think I figured something out I don't get the result I expected. I have a wiring diagram for my truck and I have identified all of the parts and junctions that I was looking for which feels like half the battle but I still haven't wrapped...
I do have a tach signal that I use for my cruise control. I will connect it to the AC amplifier and see if that will allow the clutch to turn on and then go from there. Just knowing that the AC amplifier doesn't need the ECU to operate makes this much more simple. If I cant make that work I...
I just realized that if the low pressure switch is normally closed with the truck off then it either has some pressure left from when I ran it last week or it doesn't work the way I thought it did.
I finally got some time to work on my AC. I found the thermistor and the hi and low pressure switch. They all run to the AC amplifier which talks to the ECU. Because I no longer have an ECU I need to bypass the AC amplifier.
Both the hi and the low switch are normally closed (there is...
I had the glovebox off this week and was looking around and I think I know the pig tail your talking about. I will look when I get home.
My amplifier is looking for a rpm signal which went away with the exciter when I pulled the old engine. I either need to find a way to give it the rpm...
I finally understand how a car ac system works after reading this. I understand the ideal gas law but never really got the basics of each component.
Thanks,
I've been searching and I think I can cut the wire from the factory thermistor and wire it to the switch and bypass the ac amplifier. The amplifier seems to just adjust the idle when one of several ac related conditions are met.
My problem right now is finding the thermistor. I can see it on...
I had to read that a couple of times but I understand it now. I assume that I could use the high side port that is already connected in my system. I don't guess that I would have to add one.
I was hoping to be able to use what the truck came with but I haven't figured out which is the power...
I swapped my 3.0 for a VW TDI that has been running great for the last 2500 miles but it is time to get the AC running. I connected the lines and it holds a vacuum just fine. My issue is with the wiring. I left all of the non engine wiring in the truck but the wire that went to the AC...
I have it running through a relay and the toggle switch gets its power from a key on source. I knew that I would kill the battery if it were left up to me remembering to turn it off.
I did have an optima battery die this weekend. At a stop light the turn signal went to about half speed and...