Recent content by Miljack

Just another wheel option to consider, I have the Titan7 forged wheels in 17" x 8.5" +5 PFA, not my rig... Toyota Tundra /Land Cruiser 4 Wheels F: 17X8.5 5X150 +5 / R: 17X8.5 5X150 +5 Square Disclaimer: Weights are listed based on quality control testing. Weights can vary...

I thought the computer steering sensors didn't come until the "2nd gen" 100, ie after '03??

mine is leaking like crazy from the ends, the rack itself doesn't seem like the bushings inside the housing are toast, the steering feels pretty good.

Has anyone attempted to rebuild a steering rack by themself using the factory seals, etc...? Asking about at earlier rack, 2000 model LX

HNY bump.

WTB a Dissent swing out tire mount, let me know if anyone has one they no longer need. PFA

@choyota, I looked on the Nguyen works page, don't see these rear bumpers, are they custom made only?

Sub'd to see what you come up with!

another question, is there a top mount "lift" to support the engine, or should I plan on using a screw type jack for a lift?

Not my garage, my son took a pic in a friend's garage while he was there helping him out...

Hi there, I have a LOT of work on the cruiser I need to get done, as the title states the rack is done (puking fluid out the ends), drive shafts need attention, not sure if they are done, but need to be serviced/inspected. The shocks are done, older Strutmaster AHC conversion and she's...

Hi, I'm close by, since it's a DIY, what did you finish the bumper with? Curious as I'd want to add at least one swingout mount. Does the bumper have a receiver tube built into it?

Hi there, interested, will send PM.

Nvrmnd, just remembered they got tossed!

Sold, thanks Mud, and thanks @Greenbean