Recent content by Mildot83

  1. Mildot83

    94 Non-Locked Build

    I’ve only used it a handful of times, but no problems with it. It wasn’t fun to mount it without help, and it’s a bit more bulky than I like. If I had a do over, I would get something quick detach.
  2. Mildot83

    New to 100’s

    Well, Tires happened sooner then planned. This morning actually and in the parking lot of the local YMCA. I’m sure they loved having my vehicle there on Jack stands. I’m loving the way it fills out the wheel wells. Wife says I need to paint the rims black… It’s time for her to get her hands dirty.
  3. Mildot83

    New to 100’s

    I didn’t think it was that bad until I stated cleaning it.. It was all of the carpet too. With the drill brush, I was able to run through all of it in about 1.5 hrs
  4. Mildot83

    New to 100’s

    HA! I only wish I have a shop like that. Just renting some bay space. To knock out the work
  5. Mildot83

    New to 100’s

    Thank you. Unfortunately I did not do the rear main. Hope it’s not something I’ll regret..she did get a new oil pump, starter, plugs, coils and the power steering lines to the reservoir. I’m just happy it doesn’t leak and I didn’t have any leftover bolts.
  6. Mildot83

    New to 100’s

    Picked it up for a decent price. Would have offered less if head gasket issue was known. Original engine had 228,xxx and the engine out of the Tundra had about 170,xxx. All things considered, still around 7k in.
  7. Mildot83

    New to 100’s

    Biggest take away.. When buying a used car.. bring a code reader with you. Esepecially when previous owner pulls the check engine light :( I did buy this as a project, but almost seemed more than I can chew there for a while. Learned a lot about my car though
  8. Mildot83

    New to 100’s

    To do: Diagnose and fix sound system AHC service Brake pads and rotors/ service Replace O2 sensor that is throwing a code Get these new meats installed..285/75’s
  9. Mildot83

    New to 100’s

    So far this is what has been done.. Sound deadening Recovered front seats and cleaned interior Replaced nav screen Timing belt water pump..and engine :( Fixed sliding sun roof Replaced upper A-arms Fluid replacement. Trans, diffs, t-case Flush rad Fan, fan bracket Immobilizer bypass.. thanks...
  10. Mildot83

    New to 100’s

    Then the work began…unfortunately more work than I hoped for.. what started out as doing a timing belt and water pump, quickly turned into an engine swap from a Tundra (blown head gasket). But she is running and driving on the road again
  11. Mildot83

    New to 100’s

    So, already an 80-series owner, but ended up picking up a LX470. Just starting a thread to document progress and ask some questions.. Here’s some picks when I brought her home.
  12. Mildot83

    EFI Relay Bypass Kit (Immobilizer Fix) for UZJ100/LX470

    Thank you.. Just confirmed everything and sent you an email. Thank you!
  13. Mildot83

    EFI Relay Bypass Kit (Immobilizer Fix) for UZJ100/LX470

    Looking to buy your kit. Vehicle is an 02 LX470. Thank You!
  14. Mildot83

    Ironman 4x4 Deals on Suspension, Recovery, Armor and More.

    Just tried the code this morning.. website says code “does not exist”. Hopefully it can get worked out, I’m looking forward to placing an order!
  15. Mildot83

    94 Non-Locked Build

    Took a while for it to arrive, but have some shade for the summer! Overland vehicle systems 180 awning.. I can set up and put away by myself in 5 minutes!
Back
Top Bottom