Recent content by Midgainc

  1. Midgainc

    Hinge rebuild service - maybe???

    Well, for sure never going to rebuild another set of hinges. I have a bucket of hinge parts and the custom tools (crude and simple) for dismantling them. If anyone wants them, pay the shipping a hamburger fee and You can have them. let me know. i will try to post pics.
  2. Midgainc

    just bought a 96 80....

    did all the passes except Black bear. it was closed. only time spare scrubbed was on mineral creek. they cut some really narrow and deep washes across the road when doing the repairs. when back axle went down, spare would rub. Other than that, no issues. Although nothing appears loose, my...
  3. Midgainc

    Rear Bumpers Nowadays....

    just got back from CO on a 3900 mile road trip. My next investment is a rear bumper and swing out tire, drop table. i thought all of the major bumper guys swing outs would swing wide and out of the way of tailgate/hatch AND lock in that position. Is that not the case?
  4. Midgainc

    80 Series front Swaybar Disconnects

    if i rolled around under my rig like that, i would be covered in systemic grease from fingertips to shoulders!
  5. Midgainc

    just bought a 96 80....

    i will be in Ouray around June 28
  6. Midgainc

    just bought a 96 80....

    i hope to be out there around june 28
  7. Midgainc

    just bought a 96 80....

    I put spare back on today. 14" clearance by the axle and 16" at the bumper. It rides nice right there, but off road? you tell me? Here in Georgia, we just don't have serious obstacles unless you want them. I will have room to put inside when i get to CO. I am pretty stoked about going...
  8. Midgainc

    1FZ-FE Rebuild: Would you reuse this oil pump bushing?

    It is better now, 10,000 miles later. When first start up and cold, it seems a little loud, after warm up, hardly perceptible. It did not start it until I did all of the work on it. I am 75% certain it is the power steering pump. my guess is the gear is slightly in a different spot and is...
  9. Midgainc

    just bought a 96 80....

    How difficult is it to meet up with a group and ride with them? I think especially for black bear, it would not hurt.
  10. Midgainc

    just bought a 96 80....

    Yesterday, I got jiggy with my OME 2862 and 2863 springs and new Nitrocharger shocks. I have never removed springs on the LC until now. I took 3 hours flat, including breaking tools out and putting them all back up. I ended up with about 1 to 1.25" of lift. No more body roll in turns, a...
  11. Midgainc

    just bought a 96 80....

    What about Imogene Pass? and should I dare....Black Bear?
  12. Midgainc

    just bought a 96 80....

    I have been driving it now for 3 years and have not had 1 issue appear other than egr sensor was not happy. I bypassed it with a resistor to keep CEL off. next time I get in the mood, i.may do a an egr block off. I needed the encouragement you gave back 2022 I have been driving it now for...
  13. Midgainc

    just bought a 96 80....

    I am about to take my rig out west for a bit. I would love to have a 4x4 labs rear bumper with hitch. I still have my oem one and trailer hitch. I removed receiver due to ground clearance and departure angle issue. My Toyo 305/70 spare now is the problem. It fits nicely and behaves well...
  14. Midgainc

    just bought a 96 80....

    Well, decided to swap out radiator today since there is a pin hole at the top near the puke line. THought I would give Oreillys a try. FYI, looks really close to the OEM, but it will not fit. The outlet is about 1" too far driver side and gets into the fan shroud. I worked for about 30 mins...
  15. Midgainc

    For Sale FJ80 "ARB" Style Rear Bumper with dual swing outs for Jerry Can and Spare Tire

    where are you located? does bumper have a built in trailer hitch? i am wanting to replace mine and ditch the Reese that was under it because of how low it hangs.
Back
Top Bottom