Recent content by mgriff67

  1. mgriff67

    High Idle and Surging

    Sorry, poor wording. Found the point where the tangs were not making contact and turns slightly so that the ohm meter deflected. Removed the throttle body and found this:
  2. mgriff67

    High Idle and Surging

    I have replaced and calibrated tps. I don’t have feelers but I was able to rotate ever so slightly off closed circuit to get open loop. I wonder if IACV is stuck open?
  3. mgriff67

    High Idle and Surging

    I reconnected the iacv, immediately revved up to 2k and sat there. I’m a little hesitant to let it sit and warm up that high. In the past I could pull back on the pedal and the idle would drop a little but not anymore. I’ve disconnect battery and 15a fuse trying to reset but still getting tps...
  4. mgriff67

    High Idle and Surging

    I reconnected the iacv, immediately revved up to 2k and sat there. I’m a little hesitant to let it sit and warm up that high. In the past I could pull back on the pedal and the idle would drop a little but not anymore. I’ve disconnect battery and 15a fuse trying to reset but still getting tps...
  5. mgriff67

    High Idle and Surging

    I reconnected the iacv, immediately revved up to 2k and sat there. I’m a little hesitant to let it sit and warm up that high. In the past I could pull back on the pedal and the idle would drop a little but not anymore. I’ve disconnect battery and 15a fuse trying to reset but still getting tps...
  6. mgriff67

    High Idle and Surging

    93 FZJ80. I was working on reconnecting my IACV as the plastic 6 pin connector on the harness disintegrated. I had connected the two wires supplying power and was testing the possible order that the other 4 could go. 3 combinations and it made no difference vs having the IACV disconnected then...
  7. mgriff67

    Need help diagnosing crank but no start

    94 FZJ80, yes to the dash lights flashing (hopefully i fixed the video), battery connection is secure, links all seem fine, no alarm system. I am not great with electrical so I am more so looking for techniques to diagnose.
  8. mgriff67

    Need help diagnosing crank but no start

    Try again now (if you’ve still got time to give some input)
  9. mgriff67

    Need help diagnosing crank but no start

    1. Yes, the ECU is getting power, first thing I checked as a competent person. 2. thank you for the first portion of that which was almost close to being helpful. You still managed to understand what I was asking so maybe the issue isn’t my wording…
  10. mgriff67

    Need help diagnosing crank but no start

    I get no response when I put the key into on, accessory, or crank, but when I go back to accessory from crank it lights up the dash. Unfortunately, when all the lights on the dash flash about 4x a second and I can hear a steady ticking from the driver foot we’ll relay box. If I press the brake...
  11. mgriff67

    93 FZJ80 Won't Turn Over/EFI Relay Diagnosis

    Valve itself is fine, just needed to replace the plastic 6-pin since it disintegrated.
  12. mgriff67

    93 FZJ80 Won't Turn Over/EFI Relay Diagnosis

    I spent the better part of yesterday trying to diagnose why my 93 fzj80 would crank, but not turn over. I was able to get the vehicle to turn over if I jumped the FP and power supply on the OBD port. Fuel pump will power and the motor will turn over with a little gas so I assume the issue is in...
  13. mgriff67

    Cold Start and Idle Issues

    Thank you! I very quickly went through the fuses and couldn’t find any draw from the system but this was last month. I’ll try again today and see if I can figure out where it’s coming from.
Back
Top Bottom