Recent content by MDOverlander

I figured it out. after removing the bar and one bolt you have to pull down on the plate - see picture

I’m replacing the hatch w one from another vehicle. How do I get the lock out? Na where can I get the plastic parts for the bar that connects to it (see picture)?

I’m changing the hatch on my LX450. Want to remove the hatch key cylinder. How is this done & where can I get the clips for the bar in the pictures?

Doesn’t the upstream sensor compare the O2 w the downstream sensor to adjust fuel ?

O2 Sensor bypass question… So, to put rock sliders on my 96 LX450 (35s/529 gears) I had to cut out the cats and replace it w a straight pipe. The rear part of the pipe w the downstream O2 sensor was also cut out. So, there is no rear sensor just an empty plug. Obviously the check engine light is...

This would leave the dryer exposed to getting damaged. Would have to weld metal around it to protect it

Yeah to the side.

Have a Coastal Offroad bumper that isn’t fitting on my 96 LX450 bec the AC Air Drier is in the way. Any suggestions on how to relocate it? Or, get around it? I don’t want it exposed under the bumper where it can be damaged. See picture below… PS Be cautious buying Coastal Offroad items...

Going cheap with this build. Just picked it up a few weeks ago and have about 16k on top of 13k price tag. So don’t need anything fancy at this point. But it a nice addition. Plus this build is really for my son and brother to use. I prefer driving my Tacoma

Nah…I’m not a baseline guy. My time is too valuable (5/m) Don’t have the time to wait and take it slow. I work hard and play hard.

Inside is good. I removed the 3rd row and going to add a barrier w shelf. Also raptor line it. Then wood floor for mounting of my fridge as well as other thing

I believe it’s leaning bec of the panhards. They are adjustable but I ordered a lift plate to level the panhard out. i believe it wasn’t completely lifted correctly . didn’t extend 3 of 7 break lines or add caster plates. Just lifted it 4.5 inches. Suspension lift

Do you monitor anything else I’m not towing anything. But will have 37s or 40s on it eventually. (Currently has 35s). And I’m gearing down to 529 which I already have and needs to be installed. I will be using it for overlanding. So it will be weighed down a bit.

Do you monitor anything else?