Recent content by MCJ

Daily Driver for 3 years, 325k miles, silver with tan interior, good condition, Tundra wheels plus stock set, complete extra engine plus allot of new parts, 30 inch Tiger Lights light bar, electric locking rear axle, 3rd row seats. I was going to restore the Cruiser but I now I do not have...

The calipers were rebuilt units that came with the pads installed and the rotors were new. This dragging started a little bit when they were new but now is progressively getting worse. It is even on all for wheels as the car does not pull to either side. Sometimes it will drag and sometime...

About 3 years ago I replaced front and rear calipers, rotors and fluid and I would notice every once in a while the brakes were slow to release. The problem is getting worse with the brakes staying applied even after the petal is released. It seems like it is happening to all of the wheels at...

hoser - thanks, that's what I needed.

Trunk Monkey - the owners manual that I have, that I quoted above, does not explain the operation very well at least not to the extent I would like to know.

Is there something I can read that explains its operation? What happens when you engage the center differential?

Yes the cardboard trick is great as long as you keep it rotated properly. The owners manual does not explain the system very well. It says to use the lever at "H" and the differential lock button left out for normal driving on all types of roads to wet, icy or snow covered roads. This...

I watched the video and it is a little more work than I expected. Maybe I do not understand the 4WD system very well. I thought the normal driving mode was 2WD with the front drive components free wheeling and if 4WD was wanted, then you pressed the front differential lock to send power to the...

I have a '99 LC that I would like to install part time front hubs on. Can it be done and if so does anyone have the correct ASIN part number? Also is there anything else that needs to be done when the hubs are installed. The wheel bearings have just been packed with new seals.

I have a '99 LC. I read somewhere that someone makes a special bolt for one of the fuel rails that has a schrader valve installed so a pressure check can be done. Does anyone have any info on this.

My Fob has been crushed and I do not trust it. I will contact suprarx7 and see what can be done. I need some new fobs and the electronic guts. For Dwight S, the fob is the same one in the link. Thanks for the help. I now have a place to start.

The fob I have needs to be replaced. It has been crushed and I do not trust it. I will contact supre

My problem is the keys are in good shape. I need the theft transponder and remote electronics.

I have a '99 LC with 292k miles that I just got back on the road. The main key was molded to a black fob with 3 buttons, lock, unlock and panic. Of course the fob has broken off the key. I have the fob attached to a spare key because the rig will not start without the fob. The fob is in poor...