Recent content by mbx118

Twice used (one axle) Trail Tailor front axle knuckle centering tool. You should buy it brand new and support Trail Tailor considering all his contributions to the community, but if not, this is on offer. Used it on an 84 FJ60. High quality, well made tool. I used spray on blue mark up dye...

After confidently proclaiming that I had the answer above, I was of course wrong. They dragged less but still overadjusted when I lifted the rear end and pulled the handbrake repeatedly and then freed when I spun the adjuster back in. I did switch to OEM shoes, also from cruiser outfitters and...

I have no doubt that the previous posters in this thread did this, but after having the same problem and fixing it by adjusting the bellcranks I figured I would point this out. There's a screw on the back of the bellcrank that sets the tension on the cable inside the drum. If it's too tight...

Asking $500 for the whole package. Message/make an offer if you only want a part. Bought an FJ60 (converted by the PO) with this installed behind a 2UZ, unfortunately the centered output and offset rear axle were not great at highway speeds. Based on carfax from previous owner and my usage...

Now that the weather is warming up, I'm getting a lot of hot engine compartment air blown in the cabin because I am missing the grommet that surrounds the heater pipes as they pass through the firewall. Does anyone have a good source for the replacement grommet? Cruiser corps has one that...

Yes.

Have an engine swapped cruiser, needed to clear out the kick panel and also switched the fusible links out for a fuse panel. Fusible links sold $20 each (includes shipping) Cooling fan relay - has not been tested do not know if it works, but would happily refund if it does not work when you...

Has another thought after installing a headlight harness and reading a lot of the threads on that issue. As most know, the wiring in most of these trucks is so old at this point that there’s a pretty decent voltage drop to the blower motor. Here's an article from Fluke on it...

I found them available online. # 55933-14010. Toyotapartsdeal did not have them, found them here https://shop.cruiserparts.net/index.php?main_page=product_info&products_id=65103 Partsouq or amayama may have them as well. Would echo what another poster said, best to unhook the further part...

The back adapter mates to a 60 series split case?

Didn't answer your question exactly, I'll just put this out there. Marlin made, and I think trail gear still makes an a340 to rf1a case adapter. A gear driven case that was on the minitruck and I think some 4 runners. It it is passenger side drop, but centered rear output so not ideal for...

LMK if you end up looking to split up the package. I would take everything but the engine, am located in Denver. Small garage, literally no place to put the engine. Good luck with the heart transplant, looking forward to the build thread.

Think I know the answer, but have to ask because they are so hard to find. The toybox to split case adapter is gone? Split case gone?

I wonder if anyone could post up their actual vent temps for data. With the fan at full blast, fresh air mode, vent mode, in a warmed up truck I get about 130 F at the center vent. According to the internet that's not too bad, but my other cars are hotter. I flushed the heater core about as...

I have a 2uz conversion and used a trinary to control the electric fan. The trinary threaded into my existing drier which I think was stock style. The medium pressure switch is used to trigger the fan controller (which in mine is 12v+, yours might be a ground) the hi/low contacts safety are...