Built in 2015. Full tube chassis 1974 FJ40. Original front clip and tub. Rear bed sides I made in house. I have a full set of hard doors(never installed) and brand new set of half doors (never installed) extra windshield frame. Has a 400 ford motor with custom sequential fuel injection/zf 5speed...
Here's some updated pictures of the rear. I'm now just doing a single swing out to the passenger side. Top plate is tacked on and the rear plate is cut. It ha's a 2" receiver also along with the d ring recovery points
The revcovery points are 7/8" thick on the front bumper. Give me a call at the shop and we can talk specific's if you want to order a front bumper.
The rear will be available as a simple bumper no swing outs or with swing outs.
As soon as I finish my 80 rear bumper I'll start to get the front and rears reworked to fit the 100s. The rear will definitely have a standard 2" receiver.
Im working up pricing on the rear bumper. I've already had a few people on Instagram ask also. It'll be designed for either a single swing out or duals. This 1st one is for my 80 so I'm setting it up with a longer(2/3 length) tire swing out and hi lift mount; the shorter 1/3 length with be a gas...
Let me see what I can do for a package deal on just the 8 latches.
I'm sure I could do a similar bumper for the sequoia, what gen?
Here's a sneak peek at the rear 80 bumper
I could still work on a sway bar setup if it's needed.
Yes I retro fitted my buddies prinsu with the latches I use on my racks. You have to redrill new holes over where the old mounts were.