After not making any progress on this - I took a dremel to the non OEM click in camera mount and removed enough material until the OEM camera almost fit through. Used a heat gun on a low setting and press fit the camera in there. It’s not perfect but for the last 2 weeks I haven’t had any issues!
I have a set of LC200 rear monitors with OEM Land Cruiser screen covers and headsets. No issues at all with them minus a couple small scuffs on the bottom of one of the screen housing. Recently removed these from my 2017 LC200 after installing the screen delete covers to make more room in the...
The OEM camera doesn't fit cleanly in the new mount so I'm either going to experiment with one of the supplied mounts for the new grill and cut out the center support pillar or wait until the new camera arrives and see if the wires are compatible. stay tuned!
I recently swapped my OEM grill to a blacked out one and ran into a pretty big issue with the camera mount. I didn’t realize until after I pulled off the OEM grill that it didn’t have a mount for the camera. Contacted the seller in China and after another 2 weeks, they sent me a mount that fits...
I'm battling with an AliExpress blacked out version right now that was $200 shipped and included the wings on both sides of the grill. About to make a post about it once I take the original off.
Where’d you get them from? I have a 2017 LC200 and need to remove my screens but for the cost of $200 for a set of plates. I’m inclined to just leave them on there unless the option you found is cheaper.
Are yours different than trekkboxx or victory? I need to remove my monitors to fit car seats and have a hard time stomaching $200 for my choice of metal or plastic..