Recent content by landdriver

ill give that a shot, the front end seems to rebound just a tad too much on uneven concrete. the l to h check is good at 10. when i did the bleed two months ago made sure all the fluid coming out was the color from the new fluid in the reservoir. Thanks, Paddo.

i have done all procedures on the flush. torsion bar adjustments, height check etc. the front end has very little rebound damping. should i give the fronts another bleed? fronts at 7.1 accumulator pressure at 10.5 rear at 6.1. half tank. Rig has a winch up front from the factory.

Thank you for straightening that out for me. im trying to get everything up front up to spec so i can somehow figure out how to increase the damping up front. On the comfort 2 and sport 1 setting, the front end bounces a bit too much on uneven concrete roads. The rear end damping is good. just...

My measurements on axle to fender for both left and right are practically the same but my sensors say my left side is higher by almost 4mm. Which is more of a factor for the adjustment? sensors?or physcial measurement? how do i procoeed? front pressure sensor at 6.7 rear pressure at 5.9. read...

Glad i looked this up. Time to replace the speakers.

thank you all for the input. Did the right procedure and doing the test drive this weekend.

Got it! thank you. My procedure was wrong. Had the wheels off the ground. Will redo and see if the damping improves.

HI, been around the forums and i may have faltered in the Tb adjustment procedure. What is the difference/effect between adjusting the TB's wheels up and wheels on the ground? thanks 2003 LC 100 with AHC